User’s Manual Bluetooth Adapter (Bluetooth adapter for a glucometer) BA-110 Version 0.
USA-Federal Communications Commission (FCC) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules.
Welcome z Thank you for purchasing Bluetooth adapter (BA-110). z The Bluetooth adapter is a data transmitter that receives data from a glucometer and sends the data to other devices such as a mobile phone, a gateway, etc. via Bluetooth.
Descriptions 3 ○ 2 ○ 5 ○ 4 ○ ① Body 1 ○ ② Cable ③ Connector: Connector to a glucometer ④ Button: A button used for Bluetooth manual transmission ⑤ LED: 2-color(Green and Red) LED 6 ○ 7 ○ ⑥ Label ⑦ Dry cell cover: Cover below which dry cells are put
8 ○ ⑧ Button: A button used for Bluetooth pairing How to Use 1. [Preparation] z Insert batteries. Open the cell cover to place AAA 1.5V 2 EA while checking the polarity (+,-) and then close the cover. z 2. Connect the cable to a glucometer [Bluetooth pairing] Bluetooth pairing is an authentication process between a Bluetooth adapter and a target device that readings are supposed to be sent to. There are two pairing modes for the Bluetooth adapter, BA-110.
⑤ When the LED turns RED, the Bluetooth adapter is in pairing standby mode. ⑥ Perform “Device search” in the target device and find a device named as “AMC_JandJ”. ⑦ Pair the target device with the Bluetooth adapter. PIN code is “1234”. ⑧ If the pairing succeeds, the Green LED blinks twice(2). If fails, Red LED blinks five(5) times. 3. [Data transfer] z Measure blood glucose while the adapter is being connected to a glucometer.
Cautions z Be sure to carefully read the user’s manual before use. z If you want to change the glucometer with new one, disconnect the glucometer, remove batteries, press the button several times, wait for a while, insert batteries again, and connect the new glucometer. And try to take a reading and confirm data transmission. The sequence is very important.
Customer service H3 System Co. Ltd. (Korea) Phone: +82-42-862-9314 FAX: +82-42-862-9315 E-Mail: info@h3system.co.kr Homepage: http://www.h3system.co.