French manufacturer since 1964 06/2021 www.gys.
An essential part of any semi-automatic power source, the drive rolls must be compatible with the wire feeder as well as the MIG/MAG welding wire being used. Their job is to feed the wire into the torch and therefore, introduce the wire into the welding process. The following three factors should be taken into account when selecting a drive roll: - Does the drive roll fit the reel? - Does the type of groove match the wire you are using? - Does the wire fit into this groove? 1.
B. Type of drive roll needed according to the welding station Type of drive roll No. of drive rolls Motorised drive roll Supplied drive roll SMARTMIG 110 D 2 1 90°V knurled - 0.9 SMARTMIG 142 A 2 1 35° V - 0.6 / 0.8 SMARTMIG 152 A 2 1 35° V - 0.6 / 0.8 SMARTMIG 162 A 2 1 35° V - 0.6 / 0.8 SMARTMIG 3P A 2 1 35° V - 0.6 / 0.8 SMARTMIG 182 A 2 1 35° V - 0.6 / 0.8 SMARTMIG 183 A 2 1 35° V - 0.6 / 0.8 MONOGYS 200-4CS A 4 2 35° V - 0.8 / 1.