ASSEMBLY INSTRUCTIONS BEEFER GRILL Model: BF05 Item Number: Dutton USE OUTDOORS ONLY PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY RETAIN THIS MANUAL FOR FUTURE REFERENCE `
WARNING Hazardous fire or explosion may result if instructions are ignored It is the consumer’s responsibility to see that the barbecue is properly assembled, installed, and taken care of. Failure to follow instructions in this manual could result in bodily injury and/or property damage. Read the instructions before using the appliance. Retain this manual for future reference. Use outdoors only. Warning accessible parts may be very hot. Keep young children away. Do not move the appliance during use.
Exploded view No.
WARNINGS INFORMATION IMPORTANT: Read the following instructions carefully and be sure your barbecue is properly installed, assembled and cared for. Failure to follow these instructions may result in serious bodily injury and/or property damage. If you have any questions concerning assembly or operation, consult your dealer or LPG Gas Company. When used on the ground always place the appliance and cylinder on flat level ground. Your barbecue can be used with gas cylinders between 11 kg and 15 kg.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder must never be stored where temperatures can reach over 50C. Do not store the cylinder near flames, pilot lights or other sources of ignition. DO NOT SMOKE. This barbecue is designed for use outdoors, away from any flammable materials. It is important that there are no overhead obstructions and that there is a minimum distance of 122cm from the side or rear of the appliance.
2. Make sure the control knobs are in OFF position,open gas bottle valve according to instructions. 3. Push the knob ,and turn anti-clockwise to the “MIN” position,this will light the burner. If not repeat this process. 4. Adjust the heat by turning the knob to the MAX/MIN position. 5. To turn the beefer grill OFF . Turn the cylinder valve or regulator switch to the “OFF” position and then Turn the control knob on the appliance clockwise to the OFF position. Put 1.5V battery inside before light.
TO CHECK FOR LEAKS If you smell gas:( In the event of gas leakage found) Turn off the gas supply at the gas cylinder valve. Ensure the control valve is “OFF”. Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure then turn ON the gas. Brush the soapy water onto the hose and all joints. If bubbles appear you have a leak, which must be rectified before use.
