Safety Guidelines & Installation Manual Language: English Version: 1.
Table of Contents 1 Indications for Use.......................................................................................................... 3 1.1 Symbols .................................................................................................................. 3 1.2 Safety ...................................................................................................................... 4 1.3 Intended Use ................................................................................
1 Indications for Use It is essential to read the operating instructions carefully and completely before using the first time the equipment and software. They contain important information on safety, installation and use. Keep these instructions in a safe place. 1.1 Symbols Warning of dangerous situations that can cause injury and damage to the devices. Warning of non-ionising electromagnetic radiation. Important notes and tips are a sign Info provided. Follow these guidelines.
1.2 Safety The operating and maintenance personnel must read the instructions carefully before using the equipment. Knowing all the information contained therein - in particular the warning and safety instructions - is needed to safely operate the equipment, and to protect yourself and others against possible dangers. Ignoring the warning, safety and operating instructions can result in injury, damage, or a considerable shortening of the equipment life time.
2 Delivery Contents HISCAN consists of the hydrophone logger, battery box, antenna and power cable. Additionally you can either install ALPHA V2 data collector or use ZONESCAN smart.
3 Mechanical installation. HISCAN is a high performance noise data logger, used for (semi)permanent monitoring of drinking water pipes. 3.1 Safety Precautions You must ensure that there is adequate safety present when working at great heights, deep chambers or traffic situation. Always thoroughly clean the hydrophone and fittings according to local laws and regulations, to eliminate risk of contamination of drinking water. Use protective gloves to prevent cuts from sharp edges. 3.
I 13
3.3 Directions for the External Antenna Use the provided antenna. Tighten connectors correctly to ensure good contact and sealing. No tools necessary – fingertight fastening is adequate. The antenna has a magnetic foot for easy application to ferrous surfaces, place the antenna as high as possible to ensure good radio connection with the data collector. Not using an antenna (not connecting anything to the TNC connector) may potentially damage the equipment when this is powered.
3.4.2 Battery Replacement To replace the battery, follow these steps: • • • • • Open the battery box in dry conditions only. To open the box, use a flat blade screwdriver, insert it in the small holes and gently push to the outside. Exchange the battery, pay attention to polarity. Before closing the battery box, check the seal. Remove any dirt and exchange it if damaged. Close the lid and close the latches until you hear them snap in place.
4 Technical Data 4.1 Hydrophone (model name HS401, HS501) Mechanical dimensions Diameter 63 mm Height 68 mm Hydrophone thread Female 1 ¼ Inches Weight 660g Protection class IP67 Connectors Power supply connector M8 Jack male 3 Poles Antenna connector TNC, reverse polarity Data Power Supply Parameter Min Operational temperature -30 Power supply voltage 2,5 Typ.
4.
4.3 Connectors 4.3.1 Power Connector M8 Connector 3 Pin Signal 1 No connected 3 +3,7V 4 Ground 1 4 4.3.2 Antenna Connector RP-TNC Plug 1 RF Signal case Ground 1 case 5 Storage and Transport In order to avoid unwanted radio transmissions and prevent battery depletion, disconnect the hydrophone from the battery box or remove the battery. 6 Disposal Never put electrical appliances in a household waste bin. Always collect them separately and perform an environmentally friendly recycling.
8 Conformity This radio transmitter IC: 9789A-HISCAN915V1 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.