Product Name: Diablo Cable Tie-Back SRL-LE Part #: 11097; 11098; 99-05-0033 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction 1 Applicable Safety Standards 1 Worker Classifications 1 Product Specific Applications 2 Limitations 2-3 Components and Specifications 4 Installation and Use 5-6 Maintenance, Cleaning, and Storage 7 Inspection 7 Inspection Log 7 Safety Information 8 Labels 9 - 10
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Introduction Thank you for purchasing a Guardian Fall Protection Diablo Cable Tie-Back SRL-LE. This manual must be read and understood in its entirety, and used as part of an employee training program as required by OSHA or any applicable state agency. This and any other included instructions must be made available to the user of the equipment.
• Free fall, LE Use: Maximum 5’. • Free fall, non-LE Use: Maximum 2’. Restraint: Diablo Cable Tie-Back SRL-LEs may be used in Restraint applications. Restraint systems prevent workers from reaching the leading edge of a fall hazard. Always account for fully deployed length of lanyard/SRL. Structure must withstand loads applied in the directions permitted by the system of at least 1,000 lbs. No free fall is permitted.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Diablo Cable Tie-Back SRL-LE recommended fall clearance (does not factor in any potential swing fall hazards). Clearance numbers specified based on lifeline installed vertically overhead and in-line with worker: • LE Use: 17’ (with maximum 5‘ free fall) • Non-LE Use: 7½’ (with maximum 2’ free fall) Compatibility: When making connections with Diablo Cable Tie-Back SRL-LE, eliminate all possibility of roll-out.
Lifeline length: 8’. Tie-back webbing length: 3’. www.guardianfall.com Housing Shock Absorber/ Back Pad Tie-Back Webbing Tie-Back Snap Hook Cable Lifeline Rubber Stopper Part # Description 11097 Diablo Cable Tie-Back SRL-LE w/Steel Snap Hook End. Single Leg. 11098 Diablo Cable Tie-Back SRL-LE w/Steel Snap Hook Ends. Dual Leg Kit. 99-05-0033 Diablo Cable Tie-Back SRL-LE w/Aluminum Carabiner Ends. Dual Leg Kit.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Installation and Use 1. All components of the personal fall arrest system must be selected and deemed compatible with Diablo Cable Tie-Back SRL-LE by a Competent Person. 2.
! WARNING ALWAYS adhere to the following warnings and specifications when using SRL-LEs. Diablo Cable Tie-Back SRL-LEs are tested and certified for horizontal use over a steel edge without burrs. Diablo Cable Tie-Back SRL-LEs may be used over similar surfaces, such as metal sheeting or other steel formations. The allowable angle of redirection of the lifeline portion of Diablo Cable Tie-Back SRL-LEs at the leading edge of a fall hazard MUST be at least 90° (see Image 1).
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 6305 S. 231st St., Kent, WA 98032 Guardian Fall Protection Maintenance, Cleaning, and Storage If Diablo Cable Tie-Back SRL-LE fails inspection in any way, immediately remove it from service, and contact Guardian to inquire about its return or repair. Cleaning after use is important for maintaining the safety and longevity of Diablo Cable Tie-Back SRL-LE.
Workplace conditions, including, but not limited to, flame, corrosive chemicals, electrical shock, sharp objects, machinery, abrasive substances, weather conditions, and uneven surfaces, must be assessed by a Competent Person before fall protection equipment is selected. The analysis of the workplace must anticipate where workers will be performing their duties, the routes they will take to reach their work, and the potential and existing fall hazards they may be exposed to.
www.guardianfall.com Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: (800) 466-6385 fax: (800) 670-7892 Labels STEEL SH MOUSQUETON EN ACIER GANCHO DE SEGURIDAD DE ACERO Part #: 11097 Mfg. Date Fecha de Fabricación Date de Fabrication WARNING: Prior to use, fully read and understand all manufacturer’s instructions provided with equipment at time of shipment. DO NOT ATTEMPT TO SELF SERVICE OR REPAIR! DO NOT REMOVE THIS LABEL.
www.guardianfall.com phone: (800) 466-6385 fax: (800) 670-7892 Part #: 11098 Mfg. Date Fecha de Fabricación Date de Fabrication Serial # # de Série # de Série INSPECTION: Prior to each use, inspect device per instructions, including locking function (sharp pull to test), retraction function, legibility of labels, evidence of defects, damage, or missing parts, and condition of connectors, housing, fasteners, and lifeline (inspect full length).