User's Manual

Guardian Shanghai Corp. 368,MInShen Rd, Song Jiang, Shanghai, China,201612

To Program Transmitter(s):

1. Press/release the “LEARN” button on the rear control

panel, “OK” LED will glow and beep. The unit is now

ready to accept a transmitter in the next 30 seconds as

shown in Fig.2.

2. Press/release the large grey button on the Transmitter.

(Additional buttons used for multiple garage door openers)

3. The “OK” LED will flash and beep twice indicating

transmitter is stored successfully.

Up to 20 Transmitters (including wireless keypad codes) can

be added to the unit by repeating the above procedures.

If more than 20 Transmitters are stored, the first stored

Transmitter will be replaced. (i.e. the 21st Transmitter

replaces the 1st stored Transmitter.)

Removing ALL Transmitters:

To remove ALL Transmitters from memory, press and hold

the “LEARN” button for 5 seconds. The “OK” LED will flash

and beep 2 times indicating ALL transmitters have been

removed from memory.

Replacing Transmitter Battery:

When the battery of the hand held Transmitter is low, the

indicator light will become dim and/or the range of the

Transmitter will decrease. To replace the battery, remove the

battery cover from the Transmitter as shown in Fig 3. Re-

place with a 23AE 12 volt alkaline battery with polarity shown

in Fig.3.

Fig.1

Fig.3

Visor Clip

Fig.2

LEARN

Flashes x2 x2

This device complies FCC Rules for HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate

equipment.

27AE 12 Volt

User Manual