Users Manual

21
To Program Transmitter(s):
1.
Press/release the “LEARN” button once on the rear
control
panel, “OK
” LED will glow and beep. The unit is now ready
to accept a transmitter in the next 30 seconds as shown in
Fig.2.
2.
Press/release any desired button on the Transmitter.
3. The “OK” LED will flash and beep twi
ce indi
cating
transmitter is
stored successfully.
Up to 20 Transmitters (including wireless keypad codes) can be
added to the unit by repeating the above procedures.
If more than 20 Transmitters are stored, the first stored
Transmitter will be replaced. (i.e. the 21st Transmitter replaces
the 1st stored Transmitter.)
Removing ALL Transmitters:
To remove ALL Transmitters from memory, press and hold the
“LEARN” button for 5 seconds. The “OK” LED will flash and
beep 2 times indicating. ALL transmitters have been removed
from memory.
Replacing Transmitter Battery:
When the battery of the hand held Transmitter is low, the
indicator light will become dim and/or the range of the
Transmitter will decrease. To replace the battery, remove the
battery cover from the Transmitter as shown in Fig 4. Replace
with a CR2032 battery.
This device complies FCC Rules for HOME OR OFFICE USE. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Fig.4
CR2032 battery
Fig.1
Fig.3
Fig.2
x2
Flashes
OK
LEARN
30
seconds
OK
Single and Battery
Indicator
Visor Clip
Programming D2B Handheld Remote
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the
user’s authority to operate the equipment.