Tag Reader Installation Manual and User Guide Document Number: 07-00002-000
Signpost – Installation Manual and User Guide Introduction Tag Reader is a device that is designed to operate in conjunction with a Tag and a Signpost. Basic Tag Reader functionality is shown in diagram below: 125 kHz Signpost 434 MHz Tag Tag Reader The Signpost generates modulated RF signal at 125 kHz frequency, which is detected by the Tag. Upon detection of Signpost signal, the Tag transmits its own signal on 434 MHz frequency to one or more Tag Readers.
Signpost – Installation Manual and User Guide Due to a nature of RF communication, it is hard to predict communication range between a Tag and a Tag Reader. This is heavily dependent on surrounding ambient, architecture, even people and equipment movement. However, in order to install the system, the assumption of certain communication range has to be made.
Signpost – Installation Manual and User Guide Switch configuration change can be done while the unit is powered up. Tag Reader Receiver should always have Switch 3 in position ”0” (Alarm Buzzer disabled). User Guide Functionality The functionality of Tag Reader Receiver is just tom receive messages from Tags and pass them to the Server. The functionality of Tag Reader Door Controller is more complex as it includes interaction between Tag, Signpost and peripheral door controlling hardware.
Signpost – Installation Manual and User Guide The Bypass state will last until either all the Tags leave the field or until the door is opened and closed. If the Bypass is terminated by opening and closing the door, the Tag Reader will ignore Tags that were already in the field for 5 seconds (this is Post-Bypass state), after which time it will revert to Idle state and be able to detect all the Tags again.
Signpost – Installation Manual and User Guide SPECIFICATIONS Physical Specifications Operating Temperature……………………… 32 degree F to 131 degree F Humidity ……………………………………. 0% - 90% non-condensing Size (WxHxD) ……………………………… 3.3” x 1.5” x 5.3” Weight ………………………………………. 0.3 lb. (180g) Electrical Specifications: Power Requirement …………………………. 0.3 A @ 12VDC +/- 5% RF Frequency ……………………………….. 125KHz Guard RFID Solutions Inc.
Signpost – Installation Manual and User Guide FCC Regulations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.