RD2426 User Manual Revision Record Date Revision content Disigner Revision 2021/9/28 -Initial Version Jiangjichao V1.
目录 1. PREVIEW...........................................................................................................................................................................3 2. INTRODUCTION.............................................................................................................................................................. 4 3. SPECIFICATIONS.....................................................................................................................................
1.
2. INTRODUCTION RD2426 is a MIMO radar that can swing. It is used in the UAV platform to detect the distance, speed and azimuth of obstacles and output point cloud images. The UAV uses the radar point cloud data to build a real-time 3D map, perceive the objects in the front of the UAV and independent avoidance of obstacles. 3. SPECIFICATIONS PARAMETER TEST CONDITIONS MIN TYP MAX UNIT System Features Frequency 24.05 - 24.
Speed Accuracy Point taget Angle Azimuth -40 - +40 ° Elevation -45 - 45 ° Angle Accuracy ±0.1 point target m/s ±1 ° 0.3 m 0.8 m/s 9.5 ° Multiple Targets Resolution Range Resolution point target，and 1.5~2 times of resolution can distinguish tow targets Speed Resolution Angle Resolution Point target in FOV Antenna Features TX Antenna - 2 - NA RX Antenna - 6 - NA TX Antenna Gain - - 17.
Interface Features CAN Interface CAN-FD speed - 4 - Mbps UART Interface Baudrate - 115200 - Baud/s Structure Features Size Long*width*high 94.4*88.9*138.5 Height - Material mm 174.3 - g PBT+CF 4. OPERATING CONDITIONS PARAMETER TEST CONDITIONS MIN TYP MAX UNIT Operation Voltage DC 30 50 60 V Power Consumption @50V - 6.5 - W -20 +25 +70 ° -40 25 +105 ° Working Temperature Storage Temperature Impact 500m/s²@6 ms half-sine(10 x shock each in +/-X/Y/Z dir.
6 PINs Plug NUMBER COLOR 1 Green CAN_L CAN Bus low level 2 Blue CAN_H CAN Bus high level 3 Yellow SYNC Data Synchronization 4 White NC No define 5 Red BAT+ Positive Power Input 6 Black BAT- Negative Power Input 1 Green UART_TX UART TXD signal 2 Blue UART_RX UART RXD signal 3 Red PWR 5V Power output 4 Black GND 5V Power Ground 4 PINs Plug 6.
frequency 8
FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
OEM/Host manufacturer responsibilities Must use the device only in host devices that meet the FCC/ISED RF exposure category of mobile, which means the device is installed and used at distances of at least 20cm from persons. OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module. The final product must be reassessed against all the essential requirements of the FCC rule such as FCC Part 15 Subpart B before it can be placed on the US market.
