FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
There is requirement that the grantee provide guidance to the host manufacturer for compliance with Part 15B requirements. The module complies with FCC Part Part 02, 22 H, 24 E,27, 90S and apply for Single module approval. Trace antenna designs: 4G1_MAIN 4G1_DIV (OHMS) 50 50 OHMS with tolerance ±5 ±5 Line width(mil) 12 12 length(mil) 1422 1250 The device must be professionally installed The intended use is generally not for the general public.It is generally for industry/commercial use.
Antenna type:FPC antenna Antennas: Note: Must use the same antenna type and gain equal to or lower than in the tables above. The concrete contents to check are the following three points. 1) Must use the same antenna type and gain equal to or lower than in the tables above.; 2) Should be installed so that the end user cannot modify the antenna; 3) Feed line should be designed in 50ohm Fine tuning of return loss etc. can be performed using a matching network.
Notice to OEM integrator Notice to OEM integrator Must use the device only in host devices that meet the FCC RF exposure category of mobile, which means the device is installed and used at distances of at least 20cm from persons.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The end user manual shall include FCC Part 15 compliance statements related to the transmitter as show in this manual(FCC statement).