RG HELICOPTER Sue 1D Sah THREW reverse setup Press ENT to enter the setting status, and both ELEV and the current reverse status NOR or REV are together flashing. Press flash THREW. Both THREW and its current reverse status NOR or REV are together flashing. Press let NOR flashing, and then press ENT to confirm. Press EXT to exit . 120v STICK MOD 1 12.0v STICK MOD 2 ne 100% ALE 100% Press ENT to enter the setting status, and both ELEV and the current reverse status NOR or REV are fishing. Press flash RUDDY.
Super BP RC HELICOPTER Sy 5.2 radio) settings 5.2.1 Type:Hslicopter 5.2.2 Swash type:1 Servo Normal 5.
6.1 RX2456V-D receiver features (1) The RX2456V-D receiver uses 2.4GHz spread spectrum technology with automatic scanning, codes paring and LED bind Indication functions. (2) The use of a high performance receiver dramatically reduces the possibility of signal loss and ensures the accuracy and reliability of signal reception. (3) 4-channel output makes multiple functions with fine control available. {8} Gyro sensitivity offers fine and customized adjustments to relevantly meet the habits of your operation.
Super BP AC HELICOPTER 6.3 Adjustment of receiver {1) Receiver indicator LED status: A quick flash means the signal is being received {binding in progress); a solid light means the signal was received correctly (binding was successful); a slow flash means no signal was received (binding failed).
_soreness DUPE ITI = sf 7.1 Specification and function of servo 7.1.1 Specification of servo Wright Voltage Speed Dimension WK-02-5 265g 16.5X6.8X15.7mm 7.1.2 Basel function of servo A servo is an elector-mechanical device that converts a signal from the receiver into mechanical movement. By means of a sensor the accurate control of its direction and speed is possible. 7.2 Connection and adjustment of servos 7.
Super 1519 RC HELICOPTER 8.1 Installation of battery pack Install the battery pack into the battery compartment in the direction of the row. 8.2 Tum on the power 8.2.1 Tum on the power 1. Install the battery pack In the battery 2. Tum on the power of transmitter. compartment. 3. Pull down the throttle stick and throttle trim 4.
_sophomore SUDDEN ITI = Ssh 8.2.3 Trouble shooting a flashing receiver LED after connecting the power cable Possible causes Solutions “Turn transmitter off then on and re-connect helicopter Code paling galled. power cable. The throttle tim and throttle stick of transmitter Pull down the throttle trim and throttle stick to the are not at the lowest position. lowest position and re-code pair. The transmitter battery Is low or empty. Replace transmitter battery and re-code pale (re-bind).
SUPER FIP wm 8.4 Adjustment of Main rotor blades 8.4.1 Inspection of Main rotor blades Check the following before flight or if the helicopter vibrates during fight: (1) Check if the cross-head fixing screws in the main rotor blade grips are over-tight. (2) Check if the main rotor blades are able to swing a little horizontally but not flap vertically. (3) Check if the main blades are level when rotating (tracking). {4) Check If the man blades are correctly balanced. 8.4.
AC HELICOPTER Super 10D shy kkk kk% Step 1: disconnect the power Step 2: tum off the Step 3: Remove the battery pack. cable of the helicopter. transmitter.