Mia CP AC HELICOPTER 6.1 RX2632V-D accelerate features {1) The RX2632V-D receiver uses 2.4GHz spread spectrum technology with automatic scanning, code paring and LED bind Indication functions. (2) The use of a high performance revolver dramatically reduces the possibility of signal Iss and ensures the accuracy and reliability of signal reception (3) 6-channel output makes multiple functions with fine control available.
RC HELICOPTER imi cw Ar £.4 Guideline of Calvert use (1) Status of LED indicator of receiver.quick flash means the signal is bang received; solid lighting means the signal has been abrasive; slow fish means no signal has been received. {2) Elevator/aiteron gyro muting knob:CW rotating toward increases the Environmentalist gyro sensitivity and CCW rotating toward decreases the Elevator/Aiisron gyro sensitivity.
Fatima CP AC HELICOPTER 8.1 Specification and function of servo 8.1.1 Specification of serve Weight Voltage Speed Dimension WK-024 242g 18.5X6.8X15.7mm 8.1.2 Basic function of servo A servo is an elector-mechanical device that converts a signal from the receiver info mechanical movement. By mean of a sensor the accurate control of its direction and speed is possible. 8.2 Connection and adjustment of servos 8.2.
RC HELICOPTER 9.1 Installation of battery pack Install the battery pack Into the battery compartment In the direction of the mow. Diagram of battery installation. 9.2 Tum on the power 9.2.1 Turn on the power 1. Take off the canopy, and install the battery 2. Tum on the power of transmitter. in the battery compartment. 3. Pull down the throttle stick and throttle trim 4.
Iii cP RC HELICOPTER ooh 9.2.3 Trouble shooting a flashing receiver LED after connecting the power cable Possible causes Solutions Tum transmitter off then on and re-connect helicopter Code paling galled power cation The throttle tim and throttle stick of transmitter Pull down the throttle tm and throttle stick to the are not at the lowest position. lowest position and re-code pair. The transmitter battery Is low or empty. Replace transmitter battery and re-code pale (re-bind). . .