deletion DOVE FF? eel ele 1.1 Important statements {1) Tha transmitter is suitable for experienced pills beyond 14 years old. {2} Flying the mode! illiberal in approved ground is & must. {3} We ara not responsible for any safety caused by operation, usage or control once the transmitter Is sid out. {4} Wa consign our distributors to offer technical! support and service after dais. Please contact the fiscal distributors for problem solutions caused by usage, operation, maintenance, els.
deletion Wei come to use the DOVE F7 transmitter = {3} Strictly obey the order of TURN-GM and TURN-OFF before operation. When starting your flight, tum on your transmitter first, and connect the battery to the aircraft last. When muting off the aircraft, disconnect the battery fret, and tum off your transmitter ‘ast. An upset in the order may cause your aircraft out of control.
deletion Welcome to use the DOVE F7 transmitter = 4.5 Wiring Diagram Charge jack [ 4.4 Function keys In pane! Hers ars 8 fun cons keys in the pans! of DOVE F7. Below are the details: {1} EXT: Resat kay.
detention Welcome to use the DOVE FY transmitter DOVE FZ Find the tension adjuster spring for aft and right hand throttle stick as shown below. Using a cross head screwdriver adjust the screw ringed In red below, clockwise will Increases silk tension and counter-clockwise reduces it. Replace the transmitter rear cover afire completion Adjustment Sore oan EEE There is a concessional hook in the face panel of DOVE F7.
deletion Welcome to uss the DOVE F7 transmitter = 8.1 Right-hand thrills switched to left-hand throttle (1) Mechanical step Remove the aR lateral and right lateral non-slipping blocks, respectively, remove the & screws, and then rear waver fo expose the base piste. The photo below shows the intense views of right ard left hand throttle setups.
deletion CEG FZ America to use the DOVE F7 transmitter {2} The data step Press ENT fo the Main Menu. Press move the point to System Menu, press ENT to System Menu; Press move the point to Stick Mode, press ENT fo Stick Mods Selection Menu; Press move tha precursor point to Mode 1 or Honda 3, press ENT io confirm, press EXT to exit. All saved model date will automatically be switched to be compatible with Mode 1 or Mode 3.
deletion Welcome to use the DOVE FY transmitter EVO FS {4} Training mode usage Tre default setting is they the raining 1 mods with is on the top left comer of the dynamiter, named HOLDING. When flying, i the trainer corporals the TRON switch, control is transferred control the trainee; sine, T Work will be shown on the trainer's DOVE F7. The trainees script data Is displayed on the trainers DOVE FT screen.
deletion DOVE FF 110 Receiver Installation requirement Below i some advice on how to install your equipment. {1} Using 1m thick foam, wrap the receiver and stitch § securely io the sinning using « cable Be or strong rubber band. The foam will help protect the receiver {2} it is suggested to use rubber grommets and copper washers to isolate the receiver from vibrations. Do not over tighten the screws in order that the grommets are not damaged otherwise vibration absorption will be reduced.
diddler Welcome fo use the DOVE F7 transmitter DOVE F7 This section describes the settings which are ASCII to the operation of the DOVE F7 itself. Sailings for Display, Buzzes, Vibrator, Video Select, Stick Mode, Stick Direction, Stick Calibration and About cen be accessed via the System Menu. Below is the boot screen of helicopter Helicopter Type display Model NO display . Output Power display Timer display Ge . Battery chars indicator Throttler level display: Aileron trim display Rudder trim display.
deletion Welcome to use the DOVE F7 transmitter = Setting: With the “Status” item on , press DN te nave the paint to Knob Midpoint. Use Ror L to change the status between inhibit and Active. Active means totem on Knob Midpoint buzzer white inhibit manga to turn of Knob Midpoint buzzer. {4} Tone: The buzzer tons can be spectated from 10 notes. You can sat the phone according to your preference and test ths performance. Sailing: With the “Status” loam on, press DN to move the point io Tons. from.