detention DOVE TE Welcome to use the DOVE 7E transmitter 8.2 Left-hand throttle switched to right-hand throttle (1) Mechanical switch Refer to the above “Mechanical switch” to open the transmitter cover. See the following pictures to meal the internal conditions of the left and right hand stitch.
detention Welcome to use the DOVE 7E transmitter DOVE 7E linkage icon Turn on the power of the trainer's radio. Find out the trainee’s model data, and then let the trainer's Radio bind with the aircraft model and fly It normally. Then tum off the power. Insert the other end of the digital signal wire Into the trainer's DOVE 7E, and then tum on Its power.
deletion DOVE 7E Customized fixed ID This setting will bind DOVE 7E with Its relevance In a unique corresponding relationship. it will greatly speed up the time of automatic binding when DOVE 7E powered on. (1) Hefting for fixed ID The setting for fixed ID should be under the status that automatic ID binding is successfully finished. Below is the setting method. Crass ENT to enter the Man Mani and pass move the navigational mark to select Model menu. Press ENT to enter Model Menu.
deletion DOVE 7E 11.0 Installation requirement for receiver {1) Iris important to correctly mount your radio system in your modal. Below are some advice on how to install your equipment. {2) Wrap the receiver with 10mm thickness poly foam and fix It with a rubber band or magic string on your helicopter or airplane. It helps protect the receiver. Welcome to use the DOVE 7E transmitter {3) It Is necessary for you to uss rubber grommets and copper sleeves to Isolate the vibration from the main body.
deletion eae Welcome lo use the DOVE 7E transmitter Installation requirement for DOVE 7E battery pack 3 Open the battery cover of DOVE 7E transmitter and take out the battery box. Then put 4 cells AA battery or the same size full charged NIGH battery Into the battery box. Please check again to make sure the polarities are correct. Naming: De not put the polarities of batteries In the opposite directions.
deletion DOVE 7E Leila All the functional settings, which are relative to the operation system of DOVE 7E itself, are fully integrated In System Menu. They Include Language, Display, Buzzer, vibrator, Stick Mode, Stick Direction, Stick calibration, and About Below is the boot screen of helicopter: Welcome to use the DOVE 7E transmitter Elevator tim Birthrate trim Transmission parer display wos cert Sn Model name Timer display— Model type Thor a oh play Tinges 41 TL Rudder trim display— agrarianism 1.
detention Welcome to use the DOVE 7E transmitter =r 1.3 Buzzer warning Pressing ENT 1o enter the man menu and pressing move the navigational mark to select system menu then using ENT to enter System menu. Pressing select Buzzer and pressing ENT to enter the buzzer interface. (1) Status: There are On and off two status on the Buzzer interface. Pressing move the navigational mark to the status option. Pressing change the ON or OFF status. It includes Throttle stick and Tones rems under the status Is ON.
detention DOVE 7E 1.6 Stick Direction Press ENT to enter into Main Men; Press make navigation mark at System menu. Press ENT to enter info System menu; Press choose Stick direction, press ENT to enter Into Stick direction Interface. Stick Dir action: There are four rems available as Elevator, Allison, Throttle and Rudder. Press select the stick which will sangs direction, and press change Welcome to use the DOVE 7E transmitter the direction. The factory setting is Normal. 1.
detention Welcome to use the DOVE 7E transmitter = or 2.2 Model Name In the menu of model name, you can make a desired name for your model for long term storage. Its data can be directly withdrawn In next flights Repeat the step “2.