deletion DOVE important elopements {1} The transmitter Is suitable for expedience radio controlled helicopter modelers beyond 14 years old, {2} Flying the model! aircraft in approved ground is a must. (3 We are not responsible for any safely caused by operation, usage or control as soon as the transmitter is sold out. {4} We consign our distributors fo offer technical support and service after sale. Please contact the local distributors for problem solutions caused by usage, operation, maintenance, ete.
detention DOVE 8 {3} Please strictly obey the order of urn-on and turn-off before operation. When starting your flight, turn on your transmitter first, and connect the battery fe the helicopter last. When fuming off the helicopter, disconnect tha battery first, and fin off your transmitter last. An upset in the order of connection may cause your helicopter out of control. Please cultivable a corm act habit of loom-on and tum-off.
dereliction Welcome lo use the DOVE-S transmitter EVE 8 4.3 Wiring Diagram [od] io) |] valor derv Gln Antenna DOVE Thrifts serve R¥X601 Receiver ww Bros 2 5LU9A a 4.4 Function keys In panel Hers are 6 functional keys in the pane! of DOVE-8. Below are ths details: {1} EXT: Reselling key. Press EXT to exit the main menu. {2} ENT: Confirmation key. Press ENT fo get access to the system or the function mods, {3} UP+: Function-selecting key. Move cursor up to the forward function item.
deletion EVE 8 §.2 Control stick adjustment Welcomes fo use the DOVE-8 transmitter Remove the left lateral , right lateral interlard right non-slipping blocks, respectively. Remove the fixed screws and E, and then remove the base plate. Eight non Slipping block loft littoral slipping block Below are shown the inside views of left and right throttle sets, respectively.
Rebellion DEED 8 lsh se There ars total four stick modes from MODE 1 through MODE 4. The left-hand throttle Includes MODE 2 and MODE 4, and the right-hand throttle Includes MODE 1 and MODE 3, Below are the sketch maps: Malcolm to use the DOVE-8 transmitter MODE 1 MODE 3 Right-hand stick Includes MODE 1 and MODE 3. MODE 2 MODE 4 Left-hand stick includes MODE 2 and MODE 4. 8.
detention DOVE EB Welcome to use the DOVE-S transmitter Below are shown the Inside views of left and right throttle sis, respectively. Lie cross screwdriver io loosen and remove Linkage Fixed Screw, Screw F, Screw 6, and Throttle Control Spring in right throttle sel, respectively, and then mount them In the corresponding positions In sift throttle ssl. And then adjust the stick tension according to your habit.
deletion Welcomes to use the DEED-8 transmitter BEDE Linkage Fixed Sower F The Control _ (2) The data switch Refer to the above "(8.1 } Electronic switch” to access to Stick Mode. Switch Left-hand to Right-hand throttles salsa stick model according below stick position, total 4 MODE The mods! data will be automatically switched when touching MODE 1 or MODE 8. Touch £4 to save and exit after the selection is finished.
delineation BEB Welcome fo use the DOVE-8 transmitter ‘Tum on the power of the sinner's DOVE-8. Find out the tipsiness's model data, and then let the sinner's DEVON bind with tha helicopter mods! and fiy it normally. Then tum off the power. Insert the other end of the digital signal wire into the refiner's DOVE-8, and then tum on its power.
detention EVE 8 Bm This setting will bind DOVE-8 with iis receiver in a unique corresponding relationship. it will greatly speed up the time of automatic binding when DOVE-6 powered on. {1} Setting for fixed 13 The setting for died |D should be under the status that automatic ID binding is successfully finished. Below is the setting method. Touch the icon fi to enter Model Menu, and then enter Fixed 1D by touching the icon in Mode! Menu.
deletion DOVE Important to correctly mount your remote control system In your model. Below are some advice on how to install your equipment. {1} Wrap the receiver with 10mm thick foam and soundly fix if with a rubber or mage string on your rafter model. it helps protect the receiver from damage. (23 iris necessary io use rubber grommets and copper sieves to isolate the vibrations from the main body of aircraft model. The mounting screws cannot be enlightened.
deletion Welcome to uss the DOVE-8 transmitter FEES £2) Back light teems out it is possible to set the duration which LOD stays at highlight in the form of "Always on” or any period from § to 80 seconds with an interval of § seconds. (3) Prows save time: it can adjust the back lighting duration by muting off the back light in order fo prolong the battery cruise time. The setting status constants Always On and duration in 30 grades with an interval of 1 mints. Touch £3 to exit, 4.
Celebration Welcome fo use the DOVE-8 transmitter DOVE 8 1.8 Stick Calibration Touch the iso enter System Menu and then ouch the icon to enter the interface of Stick Calibration. There are two [rems In the Interface: Stick Direction and Stick Calibration, {1} Stick direction: hens are four options: Elevator, Aileron, Throttle, and Rudder. Click the item, which you want 1 reverse, to change the output direction of the stick. The default setting is Nominal.
detention Welcome to use the DOVE-8 transmitter DOVE B 1.7 About Touch the icon iB 0 enter System Menu and then sack the versions of hardware and software. Click the Leon gto exit. Bac Mods! Menu manages all the mods! data saved in DOVE-6. It includes Modal Select, Modal Name, Model Copy, Modal Transmit, Model Receive, Mods! Reset, Type Select, Trim System, Devices Select, Device Output, Wash Type, Power Amplifier and Fixed ID.