Contents Park one: General Information 1.0 General information 2 1.1 Important statements 2 2.2 Features of DEVO-RX1002 3.0 Specification 3.1 DOVE-10 transmitter specification 3.2 Receiver specification 3 4.0 Definition of DOVE-10 == 4 4.1 Panel definition 4 4.2 Rear definition 4 4.3 Wiring Diagram chess 5 4.4 Function keys in 5 5.0 Control Stick Adjustment 5 5.1 The stick length adjustment 5 5.2 Control Stick Tension Adjustment ---6 6.0 Nick Strap Usage 8 7.0 Stick Mode Switch oo. 6 8.
.10 Tall CU IV -x= mc memes FY 3.11 Swash Mix 5 312 Poh Curve 35 3.13 Program a7 3.14 -cmvemncmnann 40 3.15 Fail 2 3.16 Sensor View 4 BAT THAN «eccl emcee een eee 22 ETHNOLOGY co om moe moan Deena a4 1.0 System Menu... cockatrices 4 1.1 Language setting 46 misplay. ea 46 1.3 Housewarming o-u a7 1.4 Vibrator a7 1.5 Stick Mode -«oc 47 1.6 Stick Direction 2.0 Model Menu «49 2.1 Mode! 29 2.2 Mote! Name== -xx-xx a9 2.3 Model 49 2.4 Mode! Wireless copy 2.5 Model regent coc -seacoast 51 2.
detention DOVE-10 0 General information 1.1 Important statements (1) The transmitter is suitable for experienced pilots beyond 14 years old. (2) Flying the mode! aircraft in approved ground is a must. (3) Wa are not responsible for any safety caused by operation, usage or control once the transmitter Is sold out. {4} We consign our distributors to offer technical support and service after sale. Please contact the local distributors for problem solutions caused by usage, operation, maintenance, etc.
detention DOVE-10 (3) Strictly obey the order of TURN-ON and TURN-OFF before operation. When starting your flight, tum on your DOVE-10 first, and connect the battery to the aircraft last. When muting off the aircraft, disconnect the battery first, and tum off your DOVE-10 last An upset in the order may cause your aircraft out of control. Cultivate a comet habit of tum-on and tum-off.
declension DEVOID-10 4.1 Panel definition Welcome to use the DOVE-10 transmitter RUDDERLESS Stick ELEV Trim RUDDY Trim UPEND 4.
detention Welcome to use the DOVE-10 transmitter DOVE-10 4.3 Wiring Diagram o Charge jack oO Oo Angara O Rudder servo DEVO-RX1002 Receiver Antenna Oo Gear servo Oo Gyro AUX 4.4 Function keys In panel Hers are 6 functional keys in the panel of DOVE-10. Below are the details: {1} EXT: Ra set key. Crass EXT to exit the main menu. (2) ENT: Confirmation key. Press ENT to access the system or the function mode. (3) UP: Moves cursor up to the forward function item.
dandelion DOVE-10 Welcomes to use the DOVE-10 transmitter 5.2 Control Stick Tension Adjustment Usa the screw driver to louse the 6 screws in the back cover, (Ba careful not to break the wires). Then use a Phillips screwdriver to adjust aah screw on the throttle arresting spring for the desired tension (Note: CW rotate to tighten the stick and CCW rotate to loosen). Control Stick Tension Adjustment Screw Ale 0 Neck Strap Usage The neck strap can ba hooked on the face of the transmitter.
detention DOVE-10 8 0 Switches between left hand and right-hand throttles The throttle switch between the left hand and right hand will be successful if both the MECHANICAL switch and ELECTRONIC switch are finished, separately. Barlow are the methods for switching: 8.
detention DEVOTED Welcome to use the DOVE-10 transmitter Linkage Fixed Screw F Throttle Control Spring CET ERT (2) The data switch Refer to the steps of *8.1 right hand throttle with to the left hand to “stick modal” The left hand throttle switch to the right hand. There are 4 stick models can be chooses at the stick position. Press UPEND to choose “model 113" and confirm via ENT keyboardist a mark “v* before the chooses mods! Press EXT to exit after setup complete. The dates can be switched automatically.
Welcome fo use the DOVE-10 transmitter ~~ dentition DOVE-10 Tramlines Is off and ring Is working Trainee Is working and trainer Is off Trainer con Training status display: when the trainer's con becomes Into X", the trainee stops flying and the trainer Is working; when the trainer's Icon tums the trainee Is flying and the trainer Is In leisure. (3) Usage method The training switch can be freely switchable between Left trim and Right trim. The default setting is Right trim.
deletion DOVE-10 Welcome to use the DOVE-10 transmitter This setting will bind DOVE-10 with its receiver in a unique corresponding relationship. It will greatly speed up the time of automatic binding when DOVE-10 powered on. (1) Setting for fixed ID The setting for fixed ID should be under the status that automatic ID binding is successfully finished. Below is the setting method. Press ENT to enter the main Menu and push move the navigational mark to select Model menu. Press ENT to enter Model Menu.