User's Manual

ManualsBrandsGuangZhou SunFieldAimo Electronic Technology ManualsElectronicsSingle Axis Wireless Express Plus Controller

MANUAL BOOK

Single Axis Wireless

Express Plus Controller

Product Name: Single Axis Wireless Express Plus Controller

Brand: CINEGEARS

Model:CG-1115,CG-1114

Manufacture: GuangZhou SunFieldAimo Electronic Technology Co., Ltd

Summary of content (5 pages)

PAGE 1
Single Axis Wireless Express Plus Controller MANUAL BOOK Product Name: Single Axis Wireless Express Plus Controller Brand: CINEGEARS Model:CG-1115,CG-1114 Manufacture: GuangZhou SunFieldAimo Electronic Technology Co., Ltd © 2017 Cine Gears INC. All Rights Reserved.
PAGE 2
Instructions Introduction The Follow Focus system is made from an aluminum alloy using precision CNC machining. The design allows the drive gear to be installed on both sides of the lens, enabling multiple drives. The product uses an accurate and precise DC servo motor and 32-bit high-speed control chips. It has an input voltage range of +12V to 30V, with an automatic voltage regulator circuit inside the controller.
PAGE 3
Instructions Remote Record Triggers Press (REC) on your controller to toggle Recording mode ON or OFF Recalibrating your Controller Rotate the focus ring clockwise to the end; hold (SET) + CODE + (REC) buttons together for 3 seconds. Rotate to the opposite end and press the three buttons again. Manual Calibration Specifically used with infinity lenses that have no start or end point.
PAGE 4
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 5
IC Warning This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.