User's Manual

USER MANUAL FOR M7114
Mouse button
l Left button
l Right button
l Scrolling wheel
l DPI
l Forward button
l Backward button
l Battery Cover
l USB Receiver
Step:
Take out the micro receiver from mouse, and plug it into the USB Port of your computer.
Insert the batteries as the show in the battery compartment for
mouse . (after you insert the batteries into the mouse, the battery indicator LED
will blinking one time)
Replace the battery cover.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Left button
Right button
Forward button
backward button
Scrolling wheel
DPI
USB Receiver
Battery Cover
power supply:DC 3V(AAA Battery*2)
operating frequency:2402.65-2480.65MHz