Installation Manual

1. After downloading and installing ,loging in to the APP;
2. When the camera is powered on ,you will hear the tone of configuration mode
(if there is no device configuration mode, please press and hold the device’s
reset button for 3 seconds to reset the device);
3. Click the plus sign on the upper right corner in the APP device list interface to
add the wireless signal camera (Figure 1 );
4. According to the (Figure 2) guide operation, After waiting for the device indicator
to flash, click “device indicator has flashed” into the scan code interface (Figure 3),
check whether the device has a QR code.
Setting installation and configauration
Wireless connection installation
Scan the QR code on the device ,and it will jump to the search device interface, then
it will display the ID of the current device (Figure 4), click the” Add button” at the below,
make it connect to the WIFI (Figure 5), user can click ” select WIFI” to select the WIFI
which near the device (Figure 6), then enter the WIFI password, click on the”connected
device “to enter the device distribution network interface (Figure 7), finally the device
distribution network will be successful.
When there is a QR code on the device
Register and log in by scanning the QR code to download and install the latest app
Download and install the latest APP
1 2 3
Fast Installation Manual
Fig 1 Fig 2 Fig 3
Fig 4 Fig 5
1
Quality . Service . Competitiveness
Before operating this unit,please read these instructions
carefully,and save them for future use.
Using the App to scan
QR code to add devices
quickly