User's Manual

1
2
Production Model 868M-IR
Power Input 3.5 dual-channel plug
Transmitting Frequency 868MHz
MFModulation Method
3
Instructions Manual For
Wireless Synchro Converter ( Radio Frequency to Infrared )
Description
Wireless Synchro Converter (RF to IR) Receiver Head
Usage
1. Connect the screen to its power source. Once the indicator
light is on, the Wireless Synchro Converter will be ready for
use ( Figure 3 ).
Figure 1
Indicator Light
Indicator Light
Figure 2
2. When using for the first time or synching with another device,
it must first be programmed. Insert a small pin into the pin insert.
With the pin inserted, press the programming button and the
indicator light will flash repeatedly ( Figure 4 ). After 60 seconds,
the programming instructions will be synced to both devices and
the program mode will end. Once complete, the indicator light
will stop flashing and stay on.
Converter Unit
3.5 Stereo Jack
External IR Insert
Indicator Light
Programming Button
Pin Insert
Wireless Synchro Converter (RF to IR)
This product can only be used in Grandview Integrated Motorized Screen with EXT CTRL input hole.
Synchro Power Relay
Ceiling
Projector Hanger
Fixation Belt
Projector
Guangzhou Grandview Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shiqiao, Panyu District, Guangzhou, Guangdong, China
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.com
Grandview Crystal Screen Canada Ltd.
#11- 3751 North Fraser Way, Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.ca
3. Clear memory keep pressing the programming button for 5 seconds and the indicator
light will flash repeatedly. Afterwards, release the programming button and press again,
the indicator light will stop flash and stay on that this step is completed.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules .These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio /TV technician for help.
WARNING
!