User's Manual

Set up for controller's batteries
1. Counter turn the remote controller and open the battery
cover according to the direction of arrow.
2. Fix in the batteries according to the figure on the left side.
3. Close the battery cover.
Please change the batteries according to the following steps when the signal of remote control
becomes weak.
Model 1GD-868Mn
UP
DOWN
STOP
MICRO-UP
MICRO-DOWN
Controller is portable, which is compatible with the receiver.
Signal is transferred by Radio wave ( 868 MHz ).
1. Push the Up button, the screen will go upwards.
2. Push the Down button, the screen will go downwards.
3. Push the stop button, the screen will stop.
4. Push the MICRO-UP button, the screen will go upwards slightly to achieve
the desired spot.
5. Push the MICRO-DOWN button, the screen will go downwards slightly to
achieve the desired spot.
Specification for controller
1. Working temperature: -5 - +40
2. Batteries for controller: 1.5V x 2, Model: A A A
3. Working properly in the generally pollution environment
4. To protect the controller, please take out of the batteries to avoid the battery's
leak when you don't use the controller for long time.
Notes for controller:
Remote control function specification
Production Model 1GD-868Mn
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules .These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio /TV technician for help.
Guangzhou Grandview Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shiqiao, Panyu District, Guangzhou, Guangdong, China
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.com
Grandview Crystal Screen Canada Ltd.
#11- 3751 North Fraser Way, Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.ca
WARNIN