Users Manual

Page 2 of 3

CZE-7C FM transmitter

First press and hold the power switch" ",

and then insert the power plug to the power jack" ".

Release the power switch" " after 3seconds, LCD screen shows the "H" or "L". Through the

"+/_" switch "H/L".

Press "+", LCD screen display "H", Press "-" LCD screen display "L". "H" is the high output

power, "L" is the low output power.

Press the power switch" "confirm settings, The LCD screendisplay"107.90MHz".Thisis the

highest frequency of use, Through the "+/_" can be changed it. Don't arbitrarily adjust.

Again press the power switch" "confirm settings, The LCD screendisplay"88.10MHz".This is

the lowest frequency of use, Through the "+/_" can be changed it. Don't arbitrarily adjust.

Press the power switch" "confirm settings, after3seconds,TheLCD screen display "OFF".

Again press the power switch" " ,The transmitter Start working.

PAGE 1
CZE-7C FM transmitter First press and hold the power switch" ", and then insert the power plug to the power jack" Release the power switch" "+/_" switch "H/L". ". " after 3seconds, LCD screen shows the "H" or "L". Through the Press "+", LCD screen display "H", Press "-" LCD screen display "L". "H" is the high output power, "L" is the low output power. Press the power switch" "confirm settings, The LCD screendisplay"107.90MHz".Thisis the highest frequency of use, Through the "+/_" can be changed it.
PAGE 2
Technical target: Power Output: <48 dBuV/m FM Transmitter Frequencies: 88.1 MHz ~107.9MHz Tuning Step: 100Khz/0.1Mhz Power Supply: 12V DC (The current load of power supply should over 2A) Stability of Frequency: ±0ppm（-10℃~+50℃） Frequency Response: 100 - 15000Hz Signal to Noise Ratio: >70dB Distortion: < 0.5% Operation Time: True 24/7 Antenna Design: External antenna with RP-SMA connector Antenna Model: FM ANT1.
PAGE 3
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.