version 1.
Device structure Before using 1. Install the data bridge. Please refer to the data bridge instruction manual. (If data bridge is already installed, skip these steps.) 2. Register for an account at www.profileplan.net and click "Create Account". Follow the instructions on screen.
Register device 1. Log into your account at www.profileplan.net and choose "My Account" > "Devices." 2. Enter your device’s serial number & click "Add Device." 3. If successful, the device will display as "Active." 4. See "Activate the Product" on the following pages if device does not display as synced.
Install batteries Activate the device 1. Bring the device within 3 feet of the data bridge. Slide off the battery cover according to the arrow direction. Install 2 AA batteries according to the marks in the battery compartment. 2. Press the power button Replace the battery cover. 5 for 5 seconds.
3. The screen will appear. Wait for the screen Operating instructions to 1. Power up the unit, press the select key to cycle through the measurement location options appear. If this screen does not display, see trouble shooting. 2. Gently pull out the tape to start measuring. 3. Wrap selected body part with tape. See trouble shooting 4. Insert the plastic end of the tape into the coupling. Press the measure key to measure and store data.
Cautions 5. The data, including those failed to be sent before, will be automatically sent to To prevent the product from harming users and to prolong product life, please follow guidelines below. the data bridge. After the data is sent the unit will turn off automatically. If there is data failure the icon will display. Symbol meaning 6. Log into www.profileplan.net to check the results or use the mobile app.
About battery use About the device 2 x AAA batteries are required for this product. Keep measuring at the same time of every day. For example, before you go to bed. If the product is not used for extended periods of time remove batteries. Measure and check the data corresponding to the part you choose. Measure close to the body to avoid interference caused by clothing. When you insert the batteries please make sure they are in the correct position.
Cleaning 1. Use a damp cloth to gently clean the device. 2. Dry the device after cleaning it.
Trouble shooting LCD error code No Display Symptom Reason/ Cause Low charge Solution Wrong battery installation 1. Wireless communication is interrupted 2.
LCD error code When using the device, the LCD displays Symptom Reason/ Cause Product is still not registered. Solution Register the device (see step 1) Data bridge limit of 16 devices has been reached Go to www.profileplan.net and delete the unused device or purchase a new data bridge. 17 Wide Band failure.
When using the device the LCD displays When using the device, the LCD displays Symptom Reason/ Cause The wireless communication between the product and data bridge is interrupted Solution Re-measure, keeping the data bridge within 3 feet of the product.
Specifications Symptom Reason/ Cause The platform of the Health Center can't indicate the measurement data normally. The measurement data is near or over the identification range. The system can’t identify Item Product Name Whole Size Wide Band failure.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.