User's Manual

ManualsBrandsGuangdong Samzuk Technology Development ManualsElectronics10 channel FRS

FWAN20A Instruction Manual - English

LCD DISPLAY ICONS

1. LCD display

2. Earphone &

Charger

Jack

3. PTT key

4. Up key

5. Down key

6. Power

On/Off key

7. Scan key

8. Menu / Key

lock key

9. Call Tone

key

10. Microphone

11. Speaker

12. Antenna

1. RX

2. TX

3. Dual Watch

4. VOX

5. APO (Auto

Power Off)

6. Battery

Level

7. Main

Channel

Number

8. CTCSS

Code

9. Speaker

Volume

10. Key Lock

11. Call

ToneScan

MAIN FEATURES

 Frequency: 462~467MHz

 Power output < 0.5W

 10 channels

 3 CTCSS code

 83 DSC code

 10 km optimal range

 Dual Watch

 3 VOX levels

 10 Call tones

 5 levels Speaker volume

 Scan

 Key lock function

 Auto Power Off

PRECAUTIONS

 Read this manual before use the radio.

 Avoid the direct exposure to solar rays and/or in front of heat.

 Do not use adaptor and/or batteries diverged from that

specified on instructions manual.

 Do not operate the radio in hazardous environments, explosion

or fire may result.

 Do not operate the radio in high humidity, dusty or explosive

environment.

 Clean by using a cloth slightly dampened. Do not use alcohol,

Summary of content (8 pages)

PAGE 1
FWAN20A Instruction Manual - English 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 1. 2. 3. 4. 5. LCD DISPLAY ICONS 6. 7. 8. 9. 10. 11. LCD display Earphone & Charger Jack PTT key Up key Down key Power On/Off key Scan key Menu / Key lock key Call Tone key Microphone Speaker Antenna RX TX Dual Watch VOX APO (Auto Power Off) Battery Level Main Channel Number CTCSS Code Speaker Volume Key Lock Call ToneScan MAIN FEATURES        Frequency: 462~467MHz Power output < 0.
PAGE 2
  solvents or abrasives etc. Do not attempt to modify the radio. The radio is designed to comply with CE and R&TTE. The LCD display is made of glass and maybe damaged if dropped or impacted. INSTALLING / REMOVING BELT CLIP Installing Belt Clip  Slide the Belt clip into the slot as shown in Figure 1. A “click” indicates the Belt Clip is locked into position. Removing Belt Clip  Pull the belt clip latch forward  While pulling the belt clip latch, push up the belt clip as shown in Figure 2.
PAGE 3
 The radio will be slightly warm during charging. GENERAL OPERATIONS 1.  TRANSMITTING RANGE The talk range depends on the environmental and terrain. It will be reach (up to about 10km) in wide open spaces, without obstructions such as hills or buildings. Don’t try to use two PMR units which are less than 1.5m (5feet) apart. If you do, you may have experience interference. 2.  POWER ON/OFF To power On the radio, press Power On/Off Key for 2 seconds until a beep is heard and the LCD display turn on.
PAGE 4
the main screen. 10. CTCSSCODE FUNCTION This function can help you select your group (3 CTCSS codes) of users on the same channel. Only the users with the same CTCSS code can listen and talk to each other. Please note that selecting a CTCSS code does not assure total privacy. In radio communication, any FRS radio can listen to all communications on the same channel when using the default standard setting with CTCSS = 0 (OFF).    Press the key twice, CTCSS code display will flash.
PAGE 5
17. AUTO POWER OFF (APO)  Press key 9 times, LCD display icon.  Press or key to select auto power off time from 0 to 6 hours.  Press PTT key to confirm and quit or press to return to Main screen.  After turning on the function, LCD will display icon and automatically turn off at designated time. 18. SCANNING CHANNELS  Press the key once and LCD will display and radio will start scanning.  LCD display shows the scanning channel one by one.  It will stop at those channels with signal for a while.
PAGE 6
SPECIFICATIONS Operation Frequency Range Modulation RF Output Power Channels CTCSS sub-code Power Supply : : : : : : 462 ~ 467MHz FM < 500mW e.r.p 10 3 AAA battery x 4 Channel Frequency Table Channel Frequency (MHz) Channel Frequency (MHz) 1 467.7125 6 467.5875 2 467.6875 7 467.5625 3 467.6625 8 462.7125 4 467.6375 9 462.6875 5 467.6125 0 462.6625 CTCSS Sub-Code Frequency Table Code Frequency (Hz) 1 110.9 2 136.5 3 186.
PAGE 7
This radio has been tested and complies with the FCC RF exposure limits for “General population.” In addition, your SANCON radio complies with the following Standards and Guidelines with regard to RF energy and electromagnetic energy levels and evaluation of such levels for exposure to humans: KDB 865664 D01 SAR Measurement 100 MHz to 6 GHz v01r03, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. • American National Standards Institute (C95.
PAGE 8
this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio. • DO NOT transmit for more than 50% of total radio use time (“50% duty cycle”). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is transmitting when the “TX indicator” lights red. You can cause the radio to transmit by pressing the “PTT” switch.