Installation Instructions

Our remote control is using RF wireless digital transmission technology. The remote kit is one-to-
one control and the re-encoding rate is less than 1/5000.(There are stickers in the back of the
transmitter and receiver with the same encoding. If it is damaged, the transmitter and receiver
must be returned to the manufacturer for repair at the same time.)
In the allowed space,lights and fans can be controlled at any angle by the transmitter.
Special Note:If both the fan and the light are equipped with the switch,please turn the fan to the
highest speed and turn on the light before the use of the remote controller.
Note:
1.This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
2.These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
3.This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
4.However, there is no guarantee that interference will not occur in a particular
installation.
5.If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Notices:
1. When the transmitter can not control the fan and light,please check whether the battery of
the remote controller is in good contact,whether the positive and negative electrodes are
placed correctly,and whether the battery power is sufficient.
2. When the transmitter can not control the fan and light, please check whether there’re similar
remote products nearby and check whether the transmitter buttons are pressed.
Because same type of remote control products transmitting the waves at the same time will
cause mutual interference. It will after the effect of the receiver. In that case, you need to find
out the cause on that, then the control function will return to normal.(Infrared remote control
products are not included.)
3. Please use within the allowable voltage range of the product. Low voltage will lead to failure of
the remote control. The voltage range and related parameters are mentioned on the product.
4. Please take out the battery if you do not use the remote controller for a long time.
5. Requirements for Circuit Load:Lamp
Bulb<1000W or H Tube<280W or energy-saving lamps<200W
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Company: GuangDong Flight Electric CO.,LTD
Address: Second Floor of No.7-5 FoShan City, GuangDong Province,
China
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.