CORDLESS TELEPHONE 25 CHANNEL AUTO SCAN Model 33030 OWNER'S MANUAL INSTALLATION AND OPERATING INSTRUCTIONS PLEASE READ THIS MANUAL CAREFULLY BEFORE USE, KEEP FOR YOUR REFERENCE. ) For Getting Started Information, please see Installation Instructions on page 8 or your separate Quick Start goods HELP LINE 1-800-338-1694 OUTSIDE THE U.S.A. CALL 1-212-242-6978 © 1987 Bell South Corporation® | 330300 1.
IN BATHHOUSE. LOW © chapel seer INDICATOR es BUTTON Pg.5 IN, @saloons, TALK BUTTON OES TONE BUTTON Pg. OEP ’ MEMO BUTTON 5) & 5 FLASH BUTTON . pm Pg. 1208 PAUSE BUTTON \& = REDIAL BUTTON Py. 5 Pg.5 For Getting Started Information, please see Installation Instructions on page 8 or your separate Quick Start guide.
Safety Instructions IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electric shock and/or injury, always folio these basic safety precautions when using your cordless telephone equipment. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephones. 2. Unplug this telephone from wall outlet before cleaning or replacing batteries. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. If necessary, + use only a mild soap.
Toe 12. Av aid using a telephone (other than a cordless type) during an electrical storm. “There may be & remote risk of electric shock from lightning. 13. Do not use the telephone to report a gas leak In the vicinity of the leak. 14. Never install telephone wiring during a lightning storm. . 15. Never install telephones jacks In wet locations unless the jack is specifically designed for wet locations. 16.
4. Channel Select Button (CH): Presto change the operating channel when yo noninterference. in Bathhouse Low Indicator: Indicates that the HANDSET is ON. Blinks wham battery Is low. (See page 18 for headstall) “Talk Button: Press to answer an incoming call or to place a call. Press to snd call. Tone Button: Press to change the dialing mode from Pulse to Tone. Memo Button: Press to stir phone numbers in memory or to call a number you have stored previously. : . .
Base Unit Controls Po war-in Connection Jack Tone/Pulse Select Switch Telephone Line Connection Jack Antenna: Raise or reposition for best reception Power-On Indicator: indicates That the unit fs ON. Charge Indicator; When the HANDSET is placed on the BASE UNIT for charging, this Indicator light wil be ON. In Use indicator: indicates when the HANDSET is in TALK mode. Page button: Press to page the HANDSET, J (Note: The gaps function is disabled when the SAVE SWITCH is ON.
Getting Started Connecting Your Phone “his section Is a reference goods to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this fate phone, refer to the Contents on page 1. 4. Carefully remove your cordials telephone from its shipping carton. Hf there is any visible damage, do not attempt to operate this equipment.
3. om BASE UNIT BASE UNIT ANTENNA TELEPHONE JACK TELEPHONE LINE CORD insert the small plug on the end of the AC adapter into the POWER-IN connection jack on the back of the BASE UNIT, Plug the AC adapter into a 120V AC wall outlet, Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE JACK arid the other end int the telephone line jack on the back of the BASE LIMIT. {if you have an older 4-prong telephone jack, you will need an R110 TELEPHONE JACK ADAPTER.
sks Press ths GAR) button to confirm that you have a dial tone. If you donor gate vial tore, review steps 3 through 10. i you still have no dial tone, feral to the Problem Solving section on page 20, 8. Thread the RUBBER ANTENNA onto the HANDSET until it is secure. 10. Be fare initial use, charge the HANDSET for 12 hours, You are now ready to use your new Southerly Cordless Telephone.
EC Wall Mounting You may choose to put the BASE UNIT of your cordless telephone on a wail. 1. With the back of the BASE UNIT facing up, Insert the flange of the WALL BRACKET info the bottom of the slots on the back of the BASE UNIT as shown. Then push the WALL MOUNT BRACKET until it locks inch place, 2. Connection SHORT TELEPHONE LINE CORD to the telephone line heck on ihe ! back of the BASE UNIT. 3.
| Preparing for Use Before you car use your cordless telephone, you must charge the HANDSET for 12 fours. Failure to do so will require recharging of the battery pack more often. 4. Place the HANDSET on the BASE UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT. 3. RAISE CR REPOSITION THE BASE UNIT ANTENNA FOR BEST RECEPTION. Before you US8 Your cordless. cellophane, you must charge the HANDSET Jor 12 hours, Aurelius to do so will require more frequent charging of the battery peck.
Reeving 2s Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, lift the HANDSET, wiser | The IN USE Indicator wil it up. 1 (Note: The HANDSET STAND BY/ SAVE ON SWITCH must be in the “STAND BY" potion) . Start your conversation, To end our conversation, either press the bunion or place the HANDSET on he BASE UNIT. If you place the HANDSET on the BASE UNIT charge cardie, you activate the autocratic STAND BY feature. WN Receiving Calls with the HANDSET off the BASE UNIT 1.
Placing Calls Press the (EER) button, The INFUSE indicator wil light up. Listen for a dial tone. Dial the phone number. : ‘When finished with your call, press the GEES bunion again. The INFUSE Indicator will um off. ron HANDSET Redial Feature if you get busy tone, press the button to hang up. Later, press the button again,» Listen fora dial tone. Press the (READ) button. This will automatically redial the last telephone number you acted.
3 gi) Numbers Storing Numbers 1, Be sure the BASE UNIT IN USE Indicator is off and the HANDSET is in STAND BY Mode (Sse special feature section). 2. Press the button. 3. Dial the number you want to store, 4. Press the: button again, 5, Dial the index numbs (+6) where you want to store that number, You will hear ane confirmation beep. . 8. Write the name of the person you will be calling with halt numbs next to the corresponding index number on the telephone card. 7.
+ Recalling Stored Numbers from Memory 1. Press the button. 2. Press the button. 3. Press the index number for the number you have stored, The stored number will be dialed autocratically. EXAMPLE: Tore cal number 703-1668 stored under key 1 on the keypad: IMPORTANT To obtain the best reception; be sure to fully trend the BASE UNIT antenna.
Your cordless telephone uses a digital coding security coding system to prevent unauthorized use of your telephone fine by another nearby cordless telephone, The system has its wn identifying signal created by microcomputers in both BASE UNIT and HANDSET. Security Code This telephone has an internal security code with 65,538 possible combinations. Each time you pick up the HANDSET, the code is randomly set to a new combination.
33030F 11.6 EL] Battery Type Use tha following type and size batty pack: Cardies Telephone Battery Pack 3.6V, 270mAR 2, U.S. Electronics inc. = Ni-MG Battery Pack: model BEE NI-MG This battery pack ls available through: U.S. Electronics Service Center 405 Madison Avernus New York, NY 10016 1-800-828-5208 Recharging the Battery Pack “The nickel metal hydroxide (Ni-MG) battery pack in the HANDSET can be recharged nanny times using the built-in charger in the BASE UNIT.
Changing the Battery Pack Changing the Battery Pack The battery pack provides power forth HANDSET of your cordless telephone. To Replace the Battery Pack: 1, Remove the HANDSET battery compartment cover by sliding it down. 2. Pull out the battery connector and remove the battery pack. 3. Plug the new battery pack info the battery connector. 4. Tide the HANDSET battery compartment cover firmly inch place in its closed position. 5.
Problem Solving Section For your assistance, we have listed below a few common problems. Phone does not work, check the following: BASE UNIT is plugged into power source. 2. HANDSET is charged. 3. TONE PULSE SWITCH is in the right position. 4, LINE CORD is plugged in the jack. PN Range of phone limited, check the following: 1. ANTENNA on BASE UNIT is raised or re positioned. 2. BASE UNIT is centrally located in your residence. 3. BASE UNIT is not located near appliances.
Excess static, check the following: 1. Check fo ses that the ANTENNA Is not touching another metal object. Reposition the ANTENNA. if after pushing the TALK button, you receive three beeps and no dial tone, check the following: 1. Resettle HANDSET by placing i on the BABE UNIT for 210 § seconds. NOTE: If no telephones in the house are working, disconnect one peseta time to verify that none of the phones are causing the problem.
$3030P22 pm 2 4 Technical Information This cordless telephones uses ratio frequencies fo allow mobility. There are certain diff cuties in using radio frequencies with cordless telephone. ‘White these are normal, the following could affect operation of your shyster. Noise Electrical pulse noise is present in most homes af one time or another, This noise is most intense during electrical storms.
Federal Communications Commission Requirements This equipment complies with Part 88 of FCC Rugs, A label on the BASE UNIT of this equipment contains, among other information, the FCC Registration Number and the Ringer Equivalence Nuremberg (REN) for this. equipment. You must, pan request, provide this information to your telephone company.
Federal Communications Commission Requirements (continued) Note: ‘This equipment has bean tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FOG Rules, Tess limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip men generates, uses and can radiate radio frequency energy and, If not installed and sed in accordance with the instructions, may cause harmful interference to radio communications.
Warranty Warranty Information Bell South Products One-Year Limited Warranty This implied warranty sets forth all Bell South Products responsibilities regarding your product, There are no other expressed of implied warranties from Bell South Products, Warranty Service Provided you purchased the new telephone from a teal] vendor, Bell South Products warrants the telephone against defects in material and workmanship for a period of ane {1) year from the original date of purchase.
SEE ECR What to Do for Warranty Service During the first thirty (30) days, a defective product is eligible for overhear-counter exchange at the retailer from wham it was purchased, After thirty (30) days, the defective product should be returned to the authorized service center. please allow 2-3 weeks for the rectum of your telephone product. The shipping address of the authorized service center is U. §.
2UIP2Z pre “This page serves as & template for attachment of screws to the wall when mounting this telephone on the wall, 1. Cutout this page. 2. Use this template to determine the distance between screws when mounting this phone on the wall. “The two truss hairs identify where to attach the screws.
IMPORTANT rt get mad mum life from the HANDSET NC eo) jor 12 hours bel IMPORTANT y Placing your BASE UNIT near appliances PE IRE I ct When you hear inter = the GH button to change the operating” channel. IMPORTANT “The AC ADAPTER must a be plug FRR et sl IMPORTANT To obtain the best reception, be SUSE io } fully extend the BAI UNIT antenna. [He SPINE ¥ you five in an mea which gets frequent re a Cee your AC adapter into a surge protector.
330304 330205 Tremble. Make certain you receive the best performance from your telephone, Read this manual first.
INTERTWINE TESTING SERVICES Exhibit E Technical Specifications, Diagrams and Photographs El Schematic of Circuit Interface to Telephone Network The interface circuitry to the telephone network is shown in Figure 2, E2 Components Affecting FCC Part 68 Compliance Reference to Figure 2 shows the values of the standard components. Additional information on the components providing isolation from the network is listed below: Relay{s): Good Sky Electronics Mfg. Co.