' CORDLESS TELEPHONE 25 CHANNEL AUTO SCAN ; Model 33012 | OWNER'S MANUAL INSTALLATION AND: OPERATING | INSTRUCTIONS | PLEASE READ'THIS MANUAL CAREFULLY BEFORE USE. KEEP FOR YOUR REFERENCE. ~ For Getting Started Information, please sea Installation Instructions on page 8 or your separate Quick Start guide. i fs | ©1995.
¢ ee] J congratulations on your affections of 2 wally Bell south product. With proper are and by following the setup and user instructions in this manual, this unl will provide idol with years of trouble free service. t Elisabeth is committed lo providing quality products that fit your needs, We would » fiche to have afy comments or suggestion you might have on this product. You may mail your comments £.8.
rv sen RUBBER ANTENNA EARPIECE 1M OBTUSE LOW LED + Ps * INDICATOR Pg5 | ; : RINGER ONION ; i . Switch TALK BUTTON ! CH (CHANNEL) SELECT, 1 Pgs | 4 BUTTON Pg517.20 L lo@e {TONE} damson ; 5, MEMO BUTTON] Pg515,48 | : ON Le 99 : FLASH BUTTON: oO REDIAL BUTTON “res | e = Pg&i4 i G BELL SOUTH 3 MICROPHONE, HANDSET RINGER Pe5 | er . Pgh | ; ; CHARGE CONTACTS | Pos For Getting Started information, please see Installation instructions on page & or your separate Quick Start guide.
EXPULSION ‘POWER SOURCE © SELECT WIGHT + CONNECTION JACK Yip . Papa ~ TELEPHONE LINE CORD JACK Pg.
IMPORTANT SAFETY INSTRUCTIONS : When using Pyotr telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric. shock and Injury to persons, Including the following: 1. Read and understand all instructions. 2. Follow all warnings and Instructions marked on the product, Fo 3. Unplug this product farm the'wall outset before cleaning. Do nat use liquid 2 { cleaners or aerosol cleaners, Use a damp sooth for cleaning.
=F URE the product has been dropped or the case has been damaged. Ff the product exhibits a distinct change in performance, 13. Do nol uae the telephone to report a gas leak in the vicinity of the leek. 14. Never install elephantine wiring ruing 8 lightning tam, 15, Aver Install telephone jacks In wet locations unless the jack Is specifically designed forwent locations. 18. Never touch insulated telephone wires or terminals unless the telephone fine has been disconnected at the network Interface. 17.
Handset Controls Obtuse Low LED Indicator: Lights up when the HANDSET Is In TALK mode. Blinks wham theta Is an incoming call. Blinks when bacillary power 15 low. (See page 18 for details.) ’ . Talk Bunion: Press to answer an incoming call ort pace 2 call. Tress to end a call ; : Tone Button: Press to temporary change featherbedding made from Pisa lo Tone for Rotary Service Users.
i [=r Unit fo Touchstone Select Switch Power-n Negotiations' Jack 3. Telephone Line Connection Jack 4, Antenna: Fully extend for bast reception. | 5. IN SUPERCHARGED Indicator: Lights up to Indicate the HANDSET is bong charged when the HANDSET Is placed on the BASE UNIT, Indicator blinks ( when the HANDSET is Jn TALK mode oF an incoming calls recanted. 6. PAGE Button: Press ta] page the HANDSET, (NOTE: The PAGE function is disabled when the RINGER switch Is OFF.
Connecting Your Phone + This section I5 reference guide to the basic functions: and operations of your cordless telephone, F ore detailed descriptions of tha operations and features of this telephone, refer to the Contents on page Carefuliyjrsmave your cordless telephone from its shipping carton. If there is an visible damage, do not attempt to operate this equipment. Return ditto the place of. purchase. | y be sure you have ali rems that come with this cordless telephone © 2.
TELEPHONE ~~ jack on the back of the BASE UNIT. . , inched one plug of the “TELEPHONE LINE CORD into the hi TELEPHONE . To avoid possible in i . TONE/PULSE Select Switch: BASE UNIT ANTENNA JACK Insert the slam pig on the end of the AC adapter into the POWER-IN connection Plug the AT adapter into 8 120 AC wail outfield. A Use only with Glass 2 Po war Source 12V DC, 200mA; JACK and the other snd info tha telephone line jack at ihe ack of the BASE UNIT.
HANDSET 3. Thread ihe RUBBER ANTENNA onto the HANDSET and tum It 40. Before unit] i . [You are now ready fo use your new ., Bell south Telephone. Press the button to confirmation you have = dls tone. if you do not get @ dial tone, review steps 3 through 8. If you still have no dial . tone, refer io the Problem Solving ‘ section on page 20. : clockwise until} charge the HANDSET for at feast 12 hours.
{ Wall Mounting i You may choose lo mount the BASE UNIT of your c : i sordidness telephone an 8 wall, Find a suitable place to mount your BASE UNIT, Mark and drill 2 holes on the wall; 100 en apart {use the wall mounting template of page 28 for your marking). | “Then fit wall-pig, If necessary, and screws leaving approximately 5 mm clear acne, Fla 2. With the back of the BASE UNIT facing up, connect the TELEPHONE LINE FORD’ Info the TELEPHONE LINE CORD JACK at the bak of the BASE UNIT. T a.
Preparing for Use Ca before you can use your cordless megaphone, you must charge the HANDSET for +2 hours. Allure to do 80 wil require recharging of the battery pack mare often, i 1. place the HANDSET on the BASE UNIT for 12 hours. i V After] 12 hours, remove the HANDSET farm ths. BABE UNIT. 3 . y EXTEND THE BASE UNIT ANTENNA FOR BEST RECEPTION. : i 3 Boors you can use your cordless telephone, you must charge the’, HANDSET for 12 hours. Failure to do so quiff require moral frequent. charging.
Receiving Galls with the HANDSET on the BASE The IN USE LED indicator wit light up. (NOTE: The HANDSET RINGER SWITCH must be in tha "ON" position.) 2. Start your conversation, 3. To end your conversation, either press the (TALK) button or place tha HANDSET on the BASE UNIT. If you claps the HANDSET on the BASE UNIT charge cradle, you semiprivate the automatic STANDBY feature, 4. When the phone rings, ift the HANDSET, | Receiving Calls with the HANDSET off the BASE UNIT 1 1.
. { | Placing Galls |! ‘y 1. Press halt button. The IN USE LED Indicator wit it up. 2. Listen for ? dial tare. 3. Disithephpne number. 4, When you have finished with your cai, pressie tuition again. The IN USE LED Indicator will turn off. oe HANDSET Redial Feature 1. Mon gal quinsy \one, press the (FAR) button to hang up. Later, pass the button again. , Listen for a dis ona. ‘Press the REDIAL) button.
7. Repeat for other telephone Numbers, i i Storing Numbers | 1 1. Embrasure BASE UNIT IN USE LED indicator fs off and the HANDSET is In STANDBY mode (See special features section). | Press the (EMG) button. Dial the number you want to store. Crass GED button again. Dial ihe index number (0-8) where you want to sire that timber. You wil hear one confirmation esp, §.
from Memory 1, Press the (TALK button, 2. Press the (MEMO) button. 4, Praiseworthiness gumbo forth + number you hav . number will be d EXAMPLE: To recall stored he the keypad: press the (TA Press the (ME! dialect, 3012p DIAPASONS Recalling Stored Numbers stored. The stored sled automatically.
Security System Security System | : Your cordless telephone uses a digital coding security stern to prevent unauthorized use of your telephone line by another nearby radiotelephone. The system fas fis own identifying signal created by microcomputers In both the BASE UNIT and HANDSET.
Battery Type Nita! Hydra This battery p 1.8, Electron 406 Madison New York, N 4500-33816! The BBL is Inter several local and Gemini Me Re colon Recharging “The nickel metal many times unis When the bale indicates that th Charge the belle pack at + battery peck can no hangar be failure, When! pack will be net “The bailey used in your potpie] Once subjected discharging pet which causes believe your b HANDSET unt charge the HAL Use only the Eid ype Cordless Telephone Battery Pack 3.6V, 250mAh 11.8.
Fon the Rr 1250S ; Changing the Battery Pack The battery pack provides power telephone. : To Replace the Battery Pack: Plug the new battery pack into the battery coronation. Eli abd position, i 5. Before use, charge the ew battery pack for 12 hours. ATTENTION: . for the HANDSET of your cordless Remove the HANDSET batiste compartment cover by sliding it down. Pull put the battery connector and remove the battery pack.
Le. 3012p1 Problem Solving Section : For your assistance, we have sifted below a few common problems. Phone does notwork, check the following: 4, Bassoonists pigged into power SOURER. 2. Handset Is charged. 3, TONE/PULSE SWITCH sn the right position. 4, TELEPHONE LINE CORD is plugged into ihe telephone jack. Range of hon limited, check the following: 4, ANTENNA gn BASE UNIT is fully extended. 2. BASE UNIT js centrally Located In your residence. 3. BASE Unities located near appliances.
+ En 3052011.6m8 Excess static, check the following: + 1. Checkpoint the ANTENNA is not touching another) Reposition ihe. ANTENNA. Co If after pressing the TALK button, you receive three heaps and no dial tone, check the following: . PC 1. Resetting HANDSET by placing ito metal object; nth BASE UNIT free 5 seconds. NOTE: If none of the’ telephones in the house are working, disconnect one sel at a ime to verify that none of the phones are causing the problem.
Sie Noels Range operating (age: gives you the backrest signal to the HANDSET. Interference Electronic circuits a bate a relay to connect the cordless telephone to your telephone ’ fine. These electronic circuits operate in he radio frequency spacious.
i “fr FCC Rp ro. Federal Communications Commission Requirements This equipment. complies with Part 88 of FCC Rules. A wen the BASE LIMIT of this equipment contains, among other information, the FCC Rex striation Nuremberg and the * Ringer Equivalence Number {REN for this equipment. You must, upon request, provide this information fo your! telephone company, .
What to Do f During the fst change at the retailer from whom lt was purchased, After flirty (30) days, the defective product should the return of your telephone product. The shipping address of the authorized service center is: NOTE: A product received which was nat made for Bell South Products or which 1.5. Electronics Service Nectar 405 Madison Avenue New York, is nol defect returned C0. To Obtain arrant Service : Provide Prepay ol shipping costs to the authorized service canter.
This page serves as a template for attachment of screws to the wall when mounting this telephone on the wall, {. Cutout his page. Cl . 2. Use this template to determine the distance batten screws when mounting this phone on the wall. . The bug cross hairs identify where to attach the Screws. 012522.
[RE I fli ayn Placing your BASE UNIT near appliances TCH ELI ise interference.
Make certain you receive the best . performance from your telephone. R ead this manual first.