User's Manual

SCREW ANCHORS
MOUNTING SCREWS
KEYPAD
PRINTER’S INSTRUCTIONS:
INSTR,INSTL, MMK100 - GTO P/N: 10015840 - INK: BLACK - MATERIAL: thin - SIZE: 11.000” X 17.00” - SCALE: 1-1
HINGED COVER
PROTECTS THE
KEYPAD
SOFT BLUE LIGHTS
ILLUMINATE THE KEYS
FOR NIGHTTIME USE
LIGHT BUTTON TURNS THE
GARAGE DOOR OPERATOR’S
LIGHT ON AND OFF WHEN THE
DOOR IS OPEN
UP/DOWN ( ) BUTTON STAYS ACTIVE FOR
30 SECONDS AFTER A CODE IS USED SO THE
OPENER CAN BE STOPPED OR REVERSED
TEN KEYS ENTERING
1-6 KEYPAD CODES
USING NUMBERS OR LETTERS
KEY FEATURES:
MMK100
DIGITAL KEYPAD
Instructions
PACKAGE INCLUDES:
PROGRAMMING A KEYPAD CODE TO THE GARAGE DOOR OPENER
Press the opener’s LEARN BUTTON for 1 second and release.
The opener should BEEP and the LIGHT should BLINK once.
The RED LED will remain lit in Learn Mode for 15 seconds.
While the RED LED is lit, enter a 1-6 digit code
into the keypad. Then PRESS and HOLD the
keypad’s START/STOP key until the opener
BEEPS and the light BLINKS once.
RED LED
Press
LEARN
button
UP
DOWN
LEARN
1 1
2
2
Repeat Steps 1 & 2 for any additional keypad codes.
Printed in China for GTO Access Systems, LLC.
Copyright
©
2016 GTO Access Systems, LLC
Document Number: 10015840 REV A
MOUNT THE KEYPAD
INCLEAR VIEW OF THE
DOORWITH THE TWO
SCREWS SUPPLIED
USE THE ANCHORS
SUPPLIED IF REQUIRED
REMOVE BATTERIES
BEFORE MOUNTING
3
INSTALL 3 FRESH
AAA BATERIES
4
SLIDE BATTERY
COVER CLOSED
1 2
SLIDE BATTERY
COVER OPEN
REMOVE THE OLD
BATTERIES AND
DISPOSE OF THEM
PROPERLY
WALL MOUNTING:
CHANGING BATTERIES:
KEYPAD OPERATION:
MIGHTY MULE LIMITED WARRANTY
This product is warranted to the consumer against defects in material and workmanship for one year from the date of purchase. This warranty
applies to rst retail buyers of new devices. Mighty Mule will repair, or at its option, replace, any device it nds that requires service under this
warranty, and will return the repaired or replaced device to the consumer at the Might Mule’s cost. For warranty service and shipping instructions
contact Mighty Mule Tech Service. Devices must be sent to Mighty Mule for service at owner’s expense. The remedies provided by this warranty
are exclusive. Implied warranties under state law are to the one year period of this written warranty. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you. In order to be protected by this warranty, save your proof of
purchase and send copy with equipment should repair be required. This warranty gives you specic legal rights, and you may also have other
rights which vary from state to state.
All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Mighty Mule Technical Services at
1-800-543-1236 for an RPA# and other important details.
Mighty Mule® is the retail brand of GTO Access Systems, LLC
3121 Hartseld Road • Tallahassee, FL 32303
Mighty Mule Sales: 800-543-4283 • Fax [phone]
Mighty Mule Technical Service 800-453-1236
For more information on Mighty Mule’s full line of Garage Door Openers, Gate Openers and Access
Controls visit www.mightymule.com
ENTER USER KEYPAD CODE
1
PRESS ( ) BUTTON
2
OVERHEAD LIGHT OPERATION
NOTE: The overhead light cannot be operated from
the keypad unless the door is open.
DAYTIME OPERATION
1
2
PRESS THE LIGHT ( ) BUTTON (TO LIGHT KEYPAD)
1
2
3
NIGHTTIME OPERATION
1-6 DIGIT KEYPAD CODE THAT
WAS ENTERED INTO OPENER
ENTER THE KEYPAD CODE
PRESS
ENTER THE KEYPAD CODE
PRESS
1-6 DIGIT KEYPAD CODE THAT
WAS ENTERED INTO OPENER
WARNING: Changes, modications or adjustments not expressly
approved by GTO Access Systems, LLC could void the user’s authority
to operate this equipment. There Are No User Serviceable Parts.
NOTICE: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This device complies with Industry Canada License-exempt RSS
standards. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device
must accept any interference, including interference that may cause
undesired operation of the device.
KEEP BATTERIES OUT REACH OF CHILDREN. Swallowing batteries
can lead to serious injury or death. If you suspect someone has
swallowed a battery, go to the hospital immediately. Do not induce
vomiting or eat or drink anything.
For more information, call the National Battery Ingestion Hotline: 202-
625-3333.
The battery identication number for this product is AAA Alkaline (LR03).
WARNING
To delete a keypad code that you no longer want
follow the same steps above. The opener will
recognize the code and delete it from memory. The
RED LED and LIGHT will blink 4 times to show the
code was successfully deleted.
DELETING A KEYPAD CODE
3 AAA batteries included.
DESCRIPTION:
This MMK100 Digital Keypad is designed for use with Mighty Mule garage door openers. The radio format provides unparalleled security
with more than a million different codes.
To activate the garage door opener, the user enters their unique 1 to 6 digit long code on the unit’s keypad and presses the ( ) button.
For up to 30 seconds after the last activation, the keypad can be re-triggered by simply pressing the ( ) button again. This allows the
user to stop or reverse the opener quickly, without having to re-enter their code.
The keypad has built-in lighting for use at night or in dark areas. The clear silicone keys are backlit with a pleasing blue glow. Pressing any
key will activate the backlight.
The keypad lockout timer will disable the keypad after 10 unsuccessful activations. The keypad must remain idle for 30 seconds before
new attempts.
The Mighty Mule garage door opener contains a built-in receiver that is
programmed by sending a signal from the keypad. This stores the keypad’s
code into the receiver’s memory. The receiver will retain its memory even
without power and will only activate from the “memorized” keypad.