User's Manual

ManualsBrandsGT-tronics HK ManualsElectronicsBC05 FLASH MODULE

User Manual

BC5MMFP(B,C) Class2 Bluetooth Module

(This module is limited to OEM Installation only)

Features

 Class 2 module with printed PCB antenna

 8Mbit (optional 16Mbit) Flash

 Fully Qualified Bluetooth 2.1 + EDR

 CSR BC5MM-EXT chip

 Low current consumption

 3.3V operation

 High quality 95db SNR on DAC playback

 PCM digital audio input/output (BC5MMFPC only)

 Support single/dual-mic input

 Interface: PIOs, UART, SPI for programming

 Built-in DSP Co-Processor for audio signal processing

 Support of noise and echo cancellation

 Configurable 5-band EQ

 802.11 Co-existence

 A2DP, AVRCP, HSP, HFP profile support

 Optional iAP, SPP profile support for app communication

 Optional AAC, MP3 direct streaming and SRS WoWHD

 Optional NFC pairing support

 RoHS compliant

 Dimension: 34.0 x 12.0 x 2.2 mm

Applications

 High Quality Mono/Stereo Wireless Headsets

 Hands-Free Car Kits

 Wireless Speakers

 Home-theater Sound Bar

 Bluetooth-Enabled Wireless Gateways

Summary of content (6 pages)

PAGE 1
User Manual BC5MMFP(B,C) Class2 Bluetooth Module (This module is limited to OEM Installation only) Features                     Class 2 module with printed PCB antenna 8Mbit (optional 16Mbit) Flash Fully Qualified Bluetooth 2.1 + EDR CSR BC5MM-EXT chip Low current consumption 3.
PAGE 2
Block Diagram BC5MMFPB(C) is a Class 2 Bluetooth sub-system using BlueCore5 –Multimedia Ext Flash chipset from leading Bluetooth chipset supplier Cambridge Silicon Radio. .It interfaces to a 8/16 MBit parallel Flash. The software stack running on the BlueCore5 MM Ext chipset is fully compliant to Bluetooth Specification v2.1 + EDR. BC5MMRPB(C) also has necessary balun and bandpass filters to interface with a build-in PCB antenna, which forms a very cost effective radio subsystem.
PAGE 3
Applications Example
PAGE 4
The above schematic shows a typical application of BC5MMFPB (C) module. Double click on the diagram to see the detail drawings. Power supply The whole module shall be supplied with a clean 3.3v at its 3V3 power port (pin #9). A coupling capacitor should be placed as close to this pin as possible. All others PIO pins (including VREG), SPI programming port and UART port will run at this power rail.
PAGE 5
LED Drivers BC5MMFPB (C) includes 2 pads dedicated to driving LED indicators. Both terminals can be controlled by firmware, The terminals are open-drain outputs, so the LED must be connected from a positive supply rail to the pad in series with a current limiting resistor. It is recommended that the LED pad, LED[0] or LED[1] pins, operate with a pad voltage below 0.5V. In this case, the pad is like a resistor, RON . The resistance together with the external series resistor sets the current in the LED.
PAGE 6
For a host using a this FCC certified modular with a standard fixed label, if (1) the module’s FCC ID is not visible when installed in the host, or (2) if the host is marketed so that end users do not have straightforward commonly used methods for access to remove the module so that the FCC ID of the module is visible; then an additional permanent label referring to the enclosed module: “Contains Transmitter Module FCC ID: B4OBC5MMFPX” or “Contains FCC ID: B4OBC5MMFPX” must be used.