FCC ID : U88GSTR-815DC-SPR ATTACHMENT E. - USER MANUAL - HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR - INDEX 1. SUMMARY................................................................................................................ 3 2. SYSTEM STRUCTURE .............................................................................................. 4 2.1 Network structure for iDEN 15dBm RF Repeater............................................................................................. 4 2.2 System Design and Operation...........................................................
FCC ID : U88GSTR-815DC-SPR 1. SUMMARY iDEN repeater is located in blanket / shadow area of insider of building to transmit iDEN800MHz, iDEN900MHz BTS signal simultaneously. There are two types of RF Repeater for iDEN band as each 15dBm, and 25dBm output power in system 65dB Gain, and 15dBm output power in system 80dB Gain. This User Manual is the Repeater having 65dBGain / +15dBm output power.
FCC ID : U88GSTR-815DC-SPR 2. SYSTEM STRUCTURE 2.1 Network structure for iDEN 15dBm RF Repeater Below picture shows a Network structure for iDEN In-building RF Repeater in a real site. Donor ANT takes a position on the direction to BTS which be linked, and Server ANT is available to be located in designated area for service by using RF cable deployments and dividers as blow. One thing that we consider is Path losses between Repeater port and ANT in case of dividing by dividers and RF cables.
FCC ID : U88GSTR-815DC-SPR 2.2 System Design and Operation 2.2.1 System design NO. ① ② ③ ④ ⑤ PART NO. PART MODEM ⑥ WAVE MONITORING ⑦ ⑧ ⑨ RVS PATH PART FWD PATH PART PSU MODULE SERVICE CAVITY FILTER DONOR CAVITY FILTER NMS BOARD I’O BOARD iDEN 15dBm internal design HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR NO. ① PORT SERVICE ANT PORT NO. ④ PART DC POWER PORT ② ③ DONOR ANT PORT AC POWER PORT ⑤ ⑥ MONITOR PORT ETHERNET PORT iDEN 15dBm PORT design 2.2.2 Downlink Path There are four (4) parts of downlink Block in iDEN In-building RF Repeater. - Filter part for Multiplex four (4) bands as each 800MHz and 900MHz TX/RX in Front End of Donor/Server - LNA part of Donor/Service path to process signals of 800MHz and 900MHz bands.
FCC ID : U88GSTR-815DC-SPR iDEN In-building RF Repeater Downlink Block Diagram 2.2.3 Uplink Path Uplink Block of iDEN In-building RF Repeater is separated as four (4) parts. - Filter part for Multiplex four (4) bands as each 800MHz and 900MHz TX/RX in Front End of Donor/Server - LNA Part of two(2) paths for processing 800MHz and 900MHz signals - 800MHz IF Converter part and 900MHz IF Converter part of 5MHz band having Switching filter parts for selecting each 18MHz and 7MHz.
FCC ID : U88GSTR-815DC-SPR iDEN In-building RF Repeater Uplink Block Diagram 2.2.4 Adjustable Band Edge functional circuit configuration In case of IDEN using the bandwidth of 800MHz and 900MHz, many of Out of Band Signals is input via Donor ANT Outdoor. The most worried signal among them is Paging Signal. Commercial Paging Signal of 929MHz~932MHz, 940MHz~941MHz, having the strength of Max. -15dBm, is to be inputted into Donor ANT.
FCC ID : U88GSTR-815DC-SPR Additional Roll off through Adjust Band Edge HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR 3. SPECIFICATIONS 3.1 System specifications Specification Characteristic 800MHz Forward Frequency Range 900MHz 800MHz Reverse 900MHz 18 MHz BAND 851~869 MHz 17.8 MHz BAND 851~868.8 MHz 17.6 MHz BAND 851~868.6MHz 7 MHz BAND 862~869 MHz 6.8 MHz BAND 862~868.8 MHz 6.6 MHz BAND 862~868.6MHz 5 MHz BAND 935~940MHz 4.8 MHz BAND 935~939.8MHz 4.6 MHz BAND 935~939.
FCC ID : U88GSTR-815DC-SPR @CH offset 1MHz @CH offset 2 MHz > 55 dBm @ Degradation of 3dB for eight iDEN carriers > 55 dBm @ Degradation of 3dB for eight iDEN carriers Adjust @ 869 MHz 868.8MHz/868.6MHz Band Edge @ 940 MHz 939.8MHz/939.6MHz Band Select Local Shift & RF Switching Roll Offs > 50dBc 3.2 Electrical and Environment Specifications Items specification Size(mm) / Type 13(W)*18(L)*4.3(H) / Inch Power AC 120V 60Hz 1.4A Temperature / Weight 0℃ ~ +50℃/16.
FCC ID : U88GSTR-815DC-SPR Oscillation Check DL Input control Automatic Recovery Security Temperature control VSWR Monitoring IP address report via E-mail DHCP Client DHCP Server Web GUI SNMP Agent LED Display • Isolation Check in initial set up or Reset • Monitoring Oscillation comparing to minimum/maximum Noise Floor level • When Oscillation occurred, repeater attempts to stabilize Isolation through Gain control function.
FCC ID : U88GSTR-815DC-SPR 4. SET UP 4.1 System Set up 4.1.1 Constitution (based on 1 SET) Parameter Item Major accessory iDEN 15dBm repeater Additional components Main power input Cable Mountable Bracket Fixable Screw Manual User Manual Quantity 1 EA 1 1 1 1 EA EA SET EA 4.1.2 Notice 1 ) System Power check : Major electricity is A C 1 2 0 V, therefore please input electricity after power verification.
FCC ID : U88GSTR-815DC-SPR Wall mounted iDEN In-building RF Repeater HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR Hole sizes of iDEN In-building RF Repeater 4.1.3 System set up 1) Once aforementioned process is done, open for service get ready. 2) For grounding, there is a grounding terminal in main power supply side and the grounding terminal on a site and unit should be connected same. 3 ) System installation work is basically performed more than two people and should be careful for unexpected accident. 4.1.4 Open for service 1) Check points before open a.
FCC ID : U88GSTR-815DC-SPR iDEN In-building RF Repeater front LED b. Verification via Debug Program User should check operation status of repeater system via Debug Program. c. Verification of operation status Use should verify following status with Output monitoring terminal, which is provided by Spectrum Analyzer. - Output power generation status, system spurious emission characteristics. d.
FCC ID : U88GSTR-815DC-SPR 5. WEB USER INTERFACE 5.1 IP Address verification and Explorer setting 5.1.1 IP Address verification (1) (2) (3) (4) Start->Control Panel->Network Connections Double-click Local Area Connections at LAN or High Speed internet Click Internet Protocol (TCP/IP) at General tap and click Properties. Apply automatic IP address assignment at local connection (5) Verify assigned IP address at local connection. (Unless IP address is not assigned, please click repair.) 5.1.
FCC ID : U88GSTR-815DC-SPR 5.2 Web UI 5.2.1 Web UI connection - Input desirable IP address. - Default Use Name and Password for Web UI is ‘admin’. 5.2.2 Link menu - Following screen shot is located left-top side of main menu and those are linked to relative window. HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR 5.3 Web UI control 5.3.1 Status - Currently setting level check at this menu tap. 5.3.2 RF Configuration - Setting level can be changed at this menu tap. - (1) Level change - (2) Click Apply button HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR 5.3.3 Alarm Configuration - (1) On/Off function for entire alarm report - (2) Alarm status - (3) On/Off function for individual alarm category - (4) Alarm SNMP Mapping - User may set and change its level per it field condition and click apply button. 5.3.4 Communication Configuration - This provides all necessary information related to network - To provide relative information about DHCP and modem HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
FCC ID : U88GSTR-815DC-SPR 5.3.5 User Management - Add and Remove user, Assigning accessibility - (1) User Registration: Click Register after input required information - (2) User Removal: Click Delete upon click of user name you wish to remove. - (3) Super User: Accessible to all kinds of information path Read/Write: Accessible to all kinds of information path except for User management path. Read: Checking status only. No control 5.3.6 Logs - All users’ access record will be saved as a log.
FCC ID : U88GSTR-815DC-SPR 5.3.7 Sub System/Mailing List - Set up e-mail address the place you wish to receive alarm. 5.3.8. Troubleshooting Following is a trouble shooting table, which is frequently occurred to repeater and treatment method. 5.3.9 Remote Software Upgrade - Upload repeater operation program. HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.
FCC ID : U88GSTR-815DC-SPR 5.3.10 System Reset - Reset repeater. HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD. SAN 136-1, AMI-RI, BUBAL-EUP, ICHEON-SI, KYOUNGKI-DO, 467-701, KOREA TEL:+82 31 639 8517 FAX:+82 31 639 8525 www.hct.co.kr Report No.