Manual

Symbol Explanation
Before charging, read the instructions
Fuse
5 RECYCLE
Separate collection. You must not discard
with usual household waste. If it is necessa-
ry to replace the machine, or if it is no more
use to you, do not discard it with household
waste. Make this machine available for sepa-
rate collection.
Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger
-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a equipment that accepts lithium-ion
batteries.
6 OPERATION
6.1 CHARGE PROCEDURE
NOTE
Before use charge the battery pack fully to make sure that
the battery pack can get the maximum run time. This battery
pack does not have a memory
. You can charge it all the
time.
1. Connect the plug of charger (2) to an AC power outlet.
2.
Put the battery pack (1) into the charger (4).
For charger: CAC801
4
3
2
1
For charger: CH60DP01
1
2
4
3
For charger: CH60R00
2
3
1
4
This is a diagnostic charger. The Charger LED Light (3)
illuminates in a specified order to show the current battery
status. They are as follows:
CHARGING PROCEDURE (LED
INDICA
TOR)
BATTERY IS CHARGING
GREEN
BLINKING
FULLY CHARGED
GREEN
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
T
O ALLOW TO COOL)
RED
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BA
T-
TERY)
RED
BLINKING
Incorrect Defect Note:
1.
Put the battery pack into the charger.
• If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LED blinks GREEN, the battery pack is
good.
5
English
EN