ZIGBEE WIRELESS MODULE User Guide Model FiOSZBMod1
Contents Chapter 1 Introduction...................................................................... 3 Purpose ........................................................................................................................... 3 Chapter 2 Frequently Asked Questions .......................................... 3 Chapter 3 Installing the ZigBee HAN module ................................. 4 Pre-requisites .................................................................................................
Chapter 1 Introduction Purpose The (FiOS-ZBMod1) HAN module is a plug-in ZigBee controller for your FiOSBHR4 Gateway. It has an integrated antenna and is all you need for enabling your Gateway to connect your SmartCloud system to supported ZigBee home automation devices such as Motion Sensors, Thermostats, Alarm systems, Smart lights and more. More than 100 ZigBee Devices can be connected simultaneously through this module.
Chapter 3 Installing the ZigBee HAN module Pre‐requisites Verify that you have everything you need: The HAN module The FiOS-BHR4 Gateway It must be powered on, connected to the network and operating normally.
An open slot for the HAN module on the backside of the FiOS-BHR4
If another module has been already installed, then it must be removed before you can install the ZigBee HAN module. Please refer to (chapter) for module uninstallation instructions. You must be logged in to your home FiOS-BHR4 Gateway as Administrator You can use either the web app or the MyFiOS App (please consult the manual for your Gateway). You must have administrator login privileges.
Step by Step Guide Step 1. Remove the HAN module port cover Use a fingernail or a flat-headed screwdriver.
Step 2. Insert the HAN module.
It can only go in with one orientation. It should slide in and come to a smooth stop with only the extraction finger handle protruding. If the module doesn't slide in very easy then verify that you have it the right way up. The HAN module label faces to the RIGHT when you watch the FiOS-BHR4 gateway from behind. Step 3. Wait for notification to appear or enter HAN settings menu.
Chapter 4 Connecting Devices to your SmartCloud TBD
Chapter 5 Notices and declarations Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.