DT-235 & DT-350 Quick User Guide Device Package One device body One AC/DC adapter Device External Interface Note: USB Port is not functional. Environmental Specification Feature Specs.
DT-235 & DT-350 Quick User Guide LED Indication LED Indicators Power & Wi-Fi Status Mode Indication VoIP Activity LTE / WiMAX Signal Strength Behavior Description Solid blue While power is supplied to the device. System is booting, or Wi-Fi disabled.
DT-235 & DT-350 Quick User Guide Before powering on the CPE, please make sure to insert the LTE SIM card provided by your service provider. Note: To insert SIM card, please make sure to follow the direction as below. The medal part of SIM card is facing bottom. Step 2: Power On Connect your CPE to power with the power cord and plug. Then, the LEDs will blink for a few seconds and go off. Step 3: Establish LTE Connection Once powered on, the CPE will automatically connect to your subscribed LTE services.
DT-235 & DT-350 Quick User Guide Using Web User Interface to Access Device Follow these steps to log in to the web management page: 1. Connect to the device via the LAN cable or WLAN. To connect WLAN, please refer to the SSID and WPA key on the device label, located on the device back. Note: In DT series product package, only one AC/DC power adapter is provided. RJ-45 or RJ11 is not included. 2.
DT-235 & DT-350 Quick User Guide Logout Reboot System 5. On the Dashboard, you can click on each section (Mobile Networks, Network, Wi-Fi, VoIP, Firewall, Management, Monitoring, and About) to see the information or detailed configurations. Below is an example on Firewall section. Note: If you make any change to the settings, make sure to click the Apply button to have the configuration take effect.
DT-235 & DT-350 Quick User Guide Claim of FCC Regulatory Compliance FCC Regulatory This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.