GREEN ENERGY BATTERY Co.,LTD Specification Approval Sheet for Lithium Ion Battery 锂离子电池产品规格确认书 MODEL/型号: SPEC/规格： C74-100B 25.
GREEN ENERGY BATTERY Co.,LTD Content 目 录 1 .Scope 适用范围 .....................................................................................................................................3 2.Battery Pack Dimension 电池组尺寸 ...................................................................................................3 3.Specification 产品规格.........................................................................................................................4 4.
GREEN ENERGY BATTERY Co.,LTD 1 .Scope 适用范围 This specification describes the basic performance, technical requirement, testing method ,warning and caution of the Li-ion rechargeable battery pack, the pack defined in this documentation is an assembly which include battery, PCM and wire, the specification only applies to GREEN ENERGY BATTERY Co., Ltd. 本标准规定了锂离子电池可充电池的基本性能、技术要求、测试方法及注意事项，电池组 合定义的是包括电芯，保护板和连接线的组合，本标准只适用于深圳市吉毅创能源科技有限公 司所生产的锂离子电池。 2.
GREEN ENERGY BATTERY Co.,LTD 3.Specification 产品规格 No. Item 3.1 Model 型号 3.2 Nominal Voltage 标称电压 3.3 Charge Cut-off Voltage 充电截止电压 Discharge Cut-off Voltage 放电截止电压 3.4 3.5 Nominal Capacity 额定容量 Spec Note C74-100 The average value of voltage during the discharge period(with standard charge and discharge).When shipping the voltage without load is between 25.9V and 29.4V. 按标准充放电后，放电过程中的电压 平均值。 25.2V 29.4V 17.5V Typ: 10Ah @ 0.2 C Min: 10Ah @ 0.
GREEN ENERGY BATTERY Co.,LTD 3.11 3.12 Operating Temperature 工作温度 Storage Temperature 储存温度 Discharge: –20℃～+60℃（放电） Charge: 0℃～+45℃（充电） -20℃~45℃ -20℃~28℃ Cells must be stored at 25.2V～25.9V. Over long storage periods cells should be cycled every 90 days. The method is to do a charge-discharge cycle with standard method, the charge to 25.2V～ 25.9V. 电芯应在 25.2V～25.
GREEN ENERGY BATTERY Co.,LTD Ambient Temperature: 25±5℃ Ambient Humidity: 45～75%RH Atmospheric Pressure： 86-106 Kpa 除非另有说明，测试应在电池出货的 1 个月内进行，且充放电循环的次数少于 5 次。本产 品规格书中的所有测试均在以下环境条件下进行： 温度： 25±5℃ 湿度： 45～75%RH 大气压： 86-106 Kpa 4.2 The requirement of measure instrument 测量设备要求 (1) (2) (3) (4) (5) (6) (7) (1) (2) (3) (4) (5) (6) (7) The measurement instrument has been certified by a qualified source. The accuracy of the measuring instrument is less than 0.01mm. The accuracy of multimeter is at least 0.5%.
GREEN ENERGY BATTERY Co.,LTD 4.5.1 4.5.2 4.5.3 4.5.4 0.2C Capacity 0.2C 容量 At standard testing condition，after standard charging, rest battery for 30min, then discharging at 0.2C to voltage 3.0V, recording the discharging time. 在标准测试环境下，标准充饱电后,搁置 30 分钟,然后用 0.2C 电流放电至 3.0V, 记录放电时间 1C Capacity 1C 容量 At standard testing condition，after standard charging, rest battery for 30min, then discharging at 1C to voltage 3.0V, recording the discharging time. 在标准测试环境下，标准充饱电后,搁置 30 分钟,然后用 1C 电流放电至 3.
GREEN ENERGY BATTERY Co.,LTD The battery pack should be stored accordance with item 3.12. In case of over-discharge, pack should be charged for one time every 3 months while storing and batteries should be discharge and charge after being stored more than a year in order to activate it and restore energy. 长期储存电池时，应符合 3.12 条款的要求。为防止电池过放，建议每 3 个月进行一次充电，如 储存时间超过一年，建议每年进行一次充、放电以激活电池. 5.
GREEN ENERGY BATTERY Co.,LTD Balanced starting voltage 均衡启动电压 4.18±0.025V Balanced current 均衡电流 <100mA Interior resistance 内阻 Internal resistance in normal operation P+,P-导通内阻 ≤10mΩ Current consumption 消耗电流 Current consume in sleep mode 静态功耗 ＜60μA Discharge over temperature protection 放电过温保护 70±4℃ Over temperature protection Discharge over temperature recover 放电过温恢复 55±4℃ 过温保护 Charge over temperature protection 充电过温保护 50±4℃ Charge over temperature recover 充电过温恢复 47±4℃ Balanced 均衡 7.
GREEN ENERGY BATTERY Co.,LTD Handling Precaution and Guideline For Lithium-Ion Rechargeable batteries Preface 前言 This document of ‘Handling Precautions and Guidelines for LI-ion Rechargeable Batteries’ shall be applied to the battery cells manufactured by GREEN ENERGY BATTERY Co., Ltd. 本文件“锂离子充电电芯操作指示及注意事项”仅适用于深圳市吉毅创能源科技有限公司生产 的电芯。 Note (1): The customer is requested to contact GREEN ENERGY in advance if and when the customer needs variations of the operating conditions described in this document.
GREEN ENERGY BATTERY Co.,LTD 充电电流 The charging current must be less than the maximum charge current specified in the specification approval Sheet. 充电电流不能超过本规格书中规定的最大充电电流。 1.2 Charging Voltage 充电电压 The charging voltage of single cell must be less than the maximum nominal voltage 4.2V, and the charging voltage upper limit is 4.3V (single pack). 单节带电池的充电电压不能超过本规格书中规定的最大标称电压 4.2V；4.3V（单节）为充 电电压最高极限。 1.
GREEN ENERGY BATTERY Co.,LTD be charged periodically to retain between3.6V and3.9V. 过放电会导致电芯性能及功能的丧失，要避免过放电。电芯长期未使用期间，它也可能会因 其自放电特性而处于某些过放电状态，为防止过放电的发生，电芯应定期充电，使其电压维 持在 3.6V 到 3.9V 之间。 5. Protective Circuit Module 保护电路模块（PCM） 5.1 The cell/battery pack shall contain a PCM that can protect the cell/ battery pack properly.
GREEN ENERGY BATTERY Co.,LTD Soft package is easily damaged by sharp objects such as needles and knives. Avoid touching ★ the cells with sharp objects when handling and storing. Next to the leads is the sealed edge. Don’t bend or fold the sealing edge as it is sensitive to ★ movement. ★ Don’t open the folded edge on the sides of the cell. ★ Don’t bend the tabs as the tabs are sensitive. ★ Avoid mechanical shock to the cells.
GREEN ENERGY BATTERY Co.,LTD ★ 电池应在远离静电的场所进行充电、使用和储存。 ★ 不要把电池同项链发夹硬币或螺钉等金属品一起放在手提包中，也不要把电池同上述物 品一起储存。 ★ 不要使用金属导体短路电池的正、负极。 ★ 在使用时应注意电池的正、负极不要反装。 ★ 不要使用带有严重变形的电池。 ★ 禁止直接焊接电池组合或电芯，禁止用钉子或其它利器剌穿电池组合或电芯。 7.2 Notice for Designing Battery Pack 电池外壳设计注意 事项 7.2.1 Package Design 外壳设计 The battery pack should have sufficient strength and the battery should be protected ① from mechanical shock. ② No sharp objects should be inside the pack containing the battery.
GREEN ENERGY BATTERY Co.,LTD f) Direct heat to the cell body is strictly prohibited. The battery will be damaged by heat above approx. 60℃. ① 建议使用超声波焊接或点焊技术来连接电芯与保护电路模块或其它部分。 ② 如使用手工锡焊，须注意以下事项，以保证电芯的功能： a） 烙铁的温度可控且防静电。 b） 烙铁的温度不能超过 350±10℃。 c） 锡焊时间不能超过 3 秒； d） 锡焊次数不能超过 5 次； e） 必须在极耳金属片冷却后再进行二次焊接； f） 禁止直接加热电芯，高于 60℃会导致电芯损坏。 7.3.2 Cell fixing 电芯的安装 8. ① The cell should be fixed to the battery pack by its large surface area. ② There should be no sharp edges at the assembly contact area.
GREEN ENERGY BATTERY Co.,LTD c. 吸入排放气体：换场所吸入新鲜空气。 d. 误食：需马上医疗就诊。 8.3 Prohibition of dumping of cells into fire Never incinerate or dispose the cells in fire, for these may cause firing of the cells. 严禁将电芯投入火中。 8.4 The cells should never be soaked with liquids such as water, drinks or oil. 严禁将电芯浸入液体中,如水,饮料,汽油等。 8.5 Prohibit using the cells mixed with different manufactories. Prohibit using new cells mixed with old ones. 禁止和不同厂家的电芯混用,禁止新旧电芯混用。 8.6 Prohibit using damaged cells. 禁止使用已损坏的电芯。 9.
GREEN ENERGY BATTERY Co.,LTD 10.FCC Statement FCC 声明 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
GREEN ENERGY BATTERY Co.,LTD 11. Statement of Bluetooth operation 蓝牙操作声明 1） Open the Bluetooth and Position Information of your mobile phone(Bluetooth of PCM is opened if battery is not out of capacity completely)打开手机上的蓝牙和位置信息（只要电池组有电，保 护板上的蓝牙模块就处于开启状态）； 2） Open the Smart Battry of your mobile phone(The Smart Battery can only check status of the battery because Bluetooth of PCM can opened automatically. The Smart Battery is supplied by GREEN ENERGY BATTERY Co.
GREEN ENERGY BATTERY Co.
GREEN ENERGY BATTERY Co.
GREEN ENERGY BATTERY Co.
