Instruction Manual

  

  

4. Replace or install the battery

3. Technical Parameters

1. Introduction



Indicator

Sound on/off

Decreased pressure

Increased pressure

Heating on/off

Mode switch

2. Functions

R10 Remote Control Instruction Manual

Model:

Frequency:

Protocol:

Battery:

R10

433MHz (1to1)

MCU learning code

DC3V CR2032 Coin Cell

8.5mA

10nA~1uA

About 30M

Working current:

stand-by current:

Launch distance:

Thank you for using this remote control. This product uses 1 to 1 coding. When the

battery is installed for the first time, it can be used directly if everything is normal

without setting. If you need to perform code matching, please press and hold the

"M" button on the main unit for three seconds, and then press the "M" button on the

remote control. After successfully matching the code, you can use it.

*This remote control has a power-off memory function, and the battery needs to be

changed without resetting.

(Open space, receiving sensitivity is -110dBm)

Use a tool to open the battery cover and insert the battery according

to the "+/-" symbol marked in the battery compartment (CR2032 or

CR2025 is common.) If you do not plan to use the remote control for

a long time, please remove the battery

PAGE 1
R10 Remote Control Instruction Manual 1. Introduction Thank you for using this remote control. This product uses 1 to 1 coding. When the battery is installed for the first time, it can be used directly if everything is normal without setting. If you need to perform code matching, please press and hold the "M" button on the main unit for three seconds, and then press the "M" button on the remote control. After successfully matching the code, you can use it.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.