Operator’s/Parts Manual 13’ End Wheel Drill Manual Marker Manufacturing, Inc. P.O. Box 5060 ● Salina, Kansas 67402-5060 ! © Copyright 1999 Printed 7/30/96 Read the Operator’s manual entirely. When you see this symbol, the subsequent instructions and warnings are serious - follow without exception.
General Information General Information Important Notice Great Plains Manufacturing, Inc. provides this publication “as is” without warranty of any kind, either expressed or implied, while every precaution has been taken in the preparation of this manual, Great Plains Manufacturing, Inc. assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Great Plains Manufacturing, Inc.
Introduction Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 1 Safety Rules . . . . . . . . . . . . . . . . . . . . . . General Operation & Repair . . . . . . . . . . . . . . . . Transporting . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 2 Assembly Instructions & Set-Up . . . . . . End Wheel Marker Installation Instructions . . . . . Torque Values Chart for UNC Threads . . . . . . . . Section 3 Maintenance & Lubrication . . . . . . . .
Section 1 Safety Rules Section 1 Safety Rules Most accidents are the result of negligence and carelessness, usually caused by failure of the operator to follow simple but necessary safety precautions. The following safety precautions are suggested to help prevent such accidents. The safe operation of any machinery is a big concern to consumers and manufacturers. Your End Wheel Marker has been designed with many built-in safety features.
Section 2 Assembly Instructions & Set-Up Assembly Diagram Figure 2-1 7/30/96 Great Plains Mfg., Inc.
Section 2 Assembly Instructions & Set-Up ! ! CAUTION! Never allow anyone near the drill when cycling the marker! WARNING! Always pin marker up for safe transporting! Torque Values Chart for UNC Threads Bolt Head Identification Bolt Size (Inches) in-tpi 4 1 Grade 2 2 Grade 5 3 N·m ft-lb N·m 1/4" - 20 7.4 5.6 1/4" - 28 8.5 6 5/16 - 18 15 5/16" - 24 3/8" - 16 Bolt Head Identification Bolt Size (Metric) Grade 8 4 5.8 8.8 10.9 Class 5.8 Class 8.8 Class 10.
Section 4 Troubleshooting Section 3 Maintenance & Lubrication Maintenance Marker Transporting Proper servicing and adjustment is the key to the long life of any farm implement. With careful and systematic inspection, you can avoid costly maintenance, time and repair. Always transport the marker with it folded in the upright position. Lubrication Universal Lubrication Symbols 50 As Required Lubrication is required every 50 hours of operation. Use a multipurpose spray lub. Use as required.
Great Plains Manufacturing, Inc. Corporate Offices: PO.
