Instructions / Assembly

DUAL GUN RACK (2-55055)

This kit is ONLY used on full size UTVs

800-643-7332

As illustrated below, this kit consists of:

TOOLS REQUIRED*

7/16” Wrench

7/16” Socket and ratchet

Gun rack mount Qty: 1

Gun cradles Qty: 4

7/16” Bolts Qty: 4

7/16” Nylon insert locking nuts Qty: 4

7/16” Flat washers Qty: 8

15975

Gun rack mount

Hand tightener

Gun Cradle

7/16” Bolts, nuts

and washers

Fig. 2

7/16” Bolt

7/16” Flat washer

7/16” Nylon insert

locking nut

Fig. 1

47”

fully extended

Procedure:

Install the gun cradles into the desired positions with the

bolts, nuts and washers as shown in figure 1 and tighten.

Loosen the hand tighteners to the point that the gun rack

will wrap around the rear brush bars of the unit. Twist the

hand tighteners until the gun rack is firmly clamped in place

to the unit as shown in figure 2.

PAGE 1
800-643-7332 DUAL GUN RACK (2-55055) As illustrated below, this kit consists of: Gun rack mount Gun cradles 7/16” Bolts 7/16” Nylon insert locking nuts 7/16” Flat washers This kit is ONLY used on full size UTVs TOOLS REQUIRED* Qty: 1 Qty: 4 Qty: 4 Qty: 4 Qty: 8 7/16” Wrench 7/16” Socket and ratchet Gun rack mount Hand tightener 7/16” Bolts, nuts and washers Gun Cradle 7/16” Flat washer 7/16” Bolt Procedure: 7/16” Nylon insert locking nut 1 Install the gun cradles into the desired positions wit