User Manual

ManualsBrandsGRAUPNER ManualsElectronics2.4GHz WiFi module

Yokomo BL-WM USER MANUAL

Thanks for purchasing BL-WM. Please carefully read this instruction manual before using this unit.

1. Introduction

This BL-WM is connected to ESC and smart device like android, i-phone, tablet pc and

program can be set with wireless system. You can also check actual racing data in real time,

and racing information up to 50mintes can be stored so that users can easily find and know

the character of the driving.

2. Specifications

z Operating voltage: 5~7.4V

z WiFi protocol: IEEE 802.11/b/g/n

z WiFi valid signal range: (0~10m, depending RF status)

z Size: 25 x 25 x 9 mm (L x W x H)

z Weight: 7g

z WiFi SSID: GRAUPNER_ESC_XXXX (MAC Address 4 )

z WiFi Password: 1234567890

3. Features

1) Wireless Programming : Easy to set ESC program such as Power Curve, Brake,

Turbo/Boost timing, etc via smart device.

2) Live function /Stop Watch: Easy to check real driving data such as

RPM/Voltage/Current/Consumed battery via Live, with Stop Watch

3) Log View: This is to store driving data for max 50min, and user can store/recall then see

the driving performance.

4) Wireless Firmware Update: User can easily update ESC/ BL-WM via smart device.

5) WiFi is On and Off according to monitor operation to minimize interference to a receiver.

Summary of content (4 pages)

PAGE 1
Yokomo BL-WM USER MANUAL Thanks for purchasing BL-WM. Please carefully read this instruction manual before using this unit. 1. Introduction This BL-WM is connected to ESC and smart device like android, i-phone, tablet pc and program can be set with wireless system. You can also check actual racing data in real time, and racing information up to 50mintes can be stored so that users can easily find and know the character of the driving. 2. Specifications z Operating voltage: 5~7.
PAGE 2
4. User Guide 1) How to connect BL-WM (Connecting the BL-WM) a) Download BL-WM Link app then install ( please refer to our homepage ) b) Like figure below, the signal of connection location for BL-WM and ESC setting should be connected with 3 pins white band of WiFi. Note: If Graupner transmitter would be used, clear SUMD V2 at CH2 setting then use. c) Connect the ESC to Power then switches on the ESC. Once WiFi works, the Yellow LED on the BL-WM should flash.
PAGE 3
on products. Choose the detected GRAUPNER_ESC WiFi. 2.1) Switch on “WiFi” setting in a smart phone. 2.2) Then, chose “GRAUPBER_ESC_(XXXX) at WiFi, then password box appears. 2.3) Initial WiFi password is 1234567890. Insert the password then check WiFi connection. 2.4) Once it is connected, click on “BL-WM APP” in a smart phone. Once APP start screen is pressed, it should move into a main screen. 2.5) Click at the right bottom of the main screen, then select WiFi item.
PAGE 4
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.