User's Manual

- 1 -

SJ 2.4GHz Transceiver Module TM01 & TM02

Integrators Installations Manual

1.Introduction

TM01 and TM02 Module consist of a 2.4GHz transceiver, Power Amplifier for 100mW output

and a Low noise Amplifier for improved receiver sensitivity.

2.Specification

1)Operating Voltage

TM01: DC 3.3V

TM02: DC 3.3V

2)Operating Current

TX Mode: 160mA

RX Mode: 35mA

3)Frequency: 2400~2483.5MHz

4)RF output Power: Max 18.

88dBm

5)Dimension

TM01: 32mm x 70mm x 5.7mm

TM02: 32.8mm x 60.05mm x 4.2mm

3.Antenna Spec

Appropriate FCC/CE/KC standards specified below 1.2dBi antenna is used.

-KMAP2440S2522T1: 2.4GHz Patch Antenna, 0dBi

-KMAP2440S2525T1: 2.4GHz Patch Antenna, 0.5dBi

-WPC.25A.07.0150C: 2.4GHz Patch Antenna, 0.5dBi

-C329-RF-001: 2.4GHz Dipole Antenna, 1.2dBi

-AT000067: 2.4GHz Dipole Antenna, 1.2dBi

PAGE 1
SJ 2.4GHz Transceiver Module TM01 & TM02 Integrators Installations Manual 1.Introduction TM01 and TM02 Module consist of a 2.4GHz transceiver, Power Amplifier for 100mW output and a Low noise Amplifier for improved receiver sensitivity. 2.Specification 1)Operating Voltage TM01: DC 3.3V TM02: DC 3.3V 2)Operating Current TX Mode: 160mA RX Mode: 35mA 3)Frequency: 2400~2483.5MHz 4)RF output Power: Max 18.88dBm 5)Dimension TM01: 32mm x 70mm x 5.7mm TM02: 32.8mm x 60.05mm x 4.2mm 3.
PAGE 2
4.Block Diagram 5.Application Schematic TM02 is controlled by J1 or J2 and J3.
PAGE 3
6.
PAGE 4
FCC Information to User This equi pment has been tested and found to com ply wi th the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim its are d esigned to provide reasona ble protection against harm ful interfere nce in a re sidential insta llation. This eq uipment ge nerates, use s and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 5
GUIDANCE REQUIREMENT / RESPONSIBILITY: Pursuant to the Transmitter Module Equipment Authorization Guide (KDB 996369 D01), the party responsible for the module grant shall provide guidance to the host manufacturer for compliance with the Part 15B requirements. Please acknowledge and document this responsibility.