User's Manual

Table Of Contents
Grand ultimate wireless
FCC ID : PVCP135
GRANDTEC ELECTRONIC CORP.
The information in this document is subject to change without notice and
does not represent a commitment on the part of the developer.
This document contains materials protected by copyright. All rights are
reserved. No part of this manual may be reproduced or transmitted in any
form, by any means or for purpose without express written consent.
FCC DECLARATION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Federal Communications Radio Frequency Interference Statement.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, Pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instruction manual may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio of television reception,
which can be determined by turning the equipment off or on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Notice :
(1) The changes or modifications not expressly approved by the party
responsible for compliance could void the user authority to operate the
equipment.
Shielded VGA cable must be used in order to comply with the emission
limits.

Summary of content (2 pages)