Installation Sheet

Faceplate
Mortise Area
Cross Bore
Hole -2-1/8”
Diameter
Edge Bore
Hole -1”
Diameter
Centerline
Door Thickness
Fo 2-3/8”
Backset:
Fo 2-3/4”
Backset:
2-3/8”
2-3/4”
DOOR PREPARATION INFORMATION
Install latch,
and rotate
latch tongue
to change
handing.
(See panel C
below)
Door Outside
Latch Tongue
Note
Bevel side of latch tongue should
contact curved end of face plate,
and curved end of strike plate.
Bevel Side
Privacy Pin Hub
Face
Plate
Curve
Strike
Plate
Curve
Door Inside
IMPORTANT:
The privacy pin hub with threads
goes on the inside of the door so it
can accept the privacy pin.
TOP
Mark here
Mark here
Passage/
privacy
Deadbolt
(if applicable)
Use the included universal
drilling template to mark the
mounting holes.
For passage/privacy
locks, insert the bottom “cup”
only, making sure the template is
vertical. Mark the bottom mounting
hole as shown, then ip the template
over (so the “cups” are facing out.)
Align the bottom drilling hole in the
template with your mark. This will
position the template so you can
mark the top mounting hole.
Drill the mounting holes
through the door using a 1/4” drill bit.
Door Outside
Screw extender
Screw extender
Emergency Release Hole
(privacy only)
1) Install the 2
screw extenders
into the exterior
Tall Plate
2) Mount the
Exterior Tall Plate
3) Check that
turning knob/
lever retracts
latch.
Door Outside
Emergency Release Hole
(privacy only)
1) Mount the
interior Tall Plate
with included
1-1/2” machine
screws.
2) Check that
turning
knob/lever
retracts
latch.
3) Screw
in the
privacy
pin.
(privacy
only)
Attach the strike plate
to the door jamb using
3/4” long wood screws.
Door Jamb
Passage/Privacy
Tall Plate Door Hardware
Installation Instructions
Tools Required: Drill, 1/4” drill bit, #2 Phillips screwdriver
Note: Passages and privacies for doors 1-3/8” to 2” thick
For assistance call 800-522-7336 Monday through Friday 7am to 5 pm Mountain Time
PK182 10062017