User's Guide

ManualsBrandsGRAND MATE ManualsElectronicsRemote controller

1/3

TX141 Remote Electronic Ignition and Control System

OPERATING INSTRUCTIONS -FOR OEM USE ONLY

Fire or explosion hazard. Attempted disassembly or repair

of controls can cause property damage, severe injury or

death. Do not disassemble the gas valve; it contains no ser-

viceable components.

Read these instructions carefully. Failure to follow them

could result in a fire or explosion causing property dam-

age, personal injury, or loss of life. The product must be installed

and operated according to all local regulations.

● Do not light any appliance.

● Do not touch any electrical switch; do not use any

phone in your building.

●

● If you cannot reach the gas supplier, call the fire de-

partment.

B. Use only your hand to push in or turn the gas control

knobs. Never use tools. If a knob will not push in or turn

by hand, don’t try to repair it, call a qualified service tech-

nician. Force or attempted repair may result in a fire or

explosion.

C. Do not use this control or any gas appliance if any part has

been under water or in contact with water. Immediately call

a qualified service technician to replace the control sys-

tem and any gas control system which has been under

water or in contact with water.

D. These instructions are to be referenced as a user guide,

and do not supersede appliance manufacturer’s lighting

instructions.

APPLICATION

TX141 is a battery-powered electronic remote ignition and

control system for gas appliances with pilot burners and ODS

systems.

GENERAL NOTES

TX141

Radio frequency Remote

434 MHz for Europe, US, Canada;

⚠WARNING

NOTE: This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This de-

vice may not cause harmful interference, and (2) This device must

accept any interference received, including interference that may

cause undesired operation. Changes or modifications not ex-

pressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency ener-

gy and, if not installed and used in accordance with the instruc-

tions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful in-

terference to radio or television reception, which can be deter-

mined by turning the equipment off and on, the user is encour-

aged to try to correct the interference by one or more of the follow-

ing measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for

help.

NOTE: This device complies with CAN ICES-3 (B)/NMB-3(B)

◆ This product meets the applicable Innovation, Science and

Economic Development Canada technical specifications.

Ce produit repond aux specifications techniques applicables a

l'innovation, Science et Developpement economique Canada.

◆ Canadian Compliance Statement

This device complies with Industry Canada license-exempt

RSSs. Operation is subject to the following two conditions:

1) This device may not cause interference, and

2) This device must accept any interference, including

interference that may cause undesired operation of the

device.

Le present appareil est conforme aux CNR d’Industrie Canada

applicables aux appareils radio exempts de licence. L’exploita-

tion est autorisee aux deux conditions suivantes :

1) l’appareil ne doit pas produire de brouillage;

2) l’utilisateur de l’appareil doit accepter tout brouillage

radioelectrique subi, meme si le brouillage est suscepti-

ble d’en compromettre le fonctionnement.

Batteries - Remote Handset:

3 x1.5V “AAA” (quality alkaline recommended)

4.5V 100mA

NOTE: These remote handsets, receiver, wall switches, are not in-

terchangeable with previous versions.

For all lighting/ignition instructions please refer to appliance manu-

facturer’s instructions.

Summary of content (3 pages)

PAGE 1
TX141 Remote Electronic Ignition and Control System OPERATING INSTRUCTIONS -FOR OEM USE ONLY TX141 ⚠WARNING Fire or explosion hazard. Attempted disassembly or repair of controls can cause property damage, severe injury or death. Do not disassemble the gas valve; it contains no serviceable components. Read these instructions carefully. Failure to follow them could result in a fire or explosion causing property damage, personal injury, or loss of life.
PAGE 2
TX141—Operating Instructions D03 TX141 SERIES REMOTE HANDSET FEATURES TX140 TX120 Remote 434MHz TX141 TX120 TX140 TX141 ON/ OFF ★ ★ ★ Childproof ★ ★ ★ Revo Home Compatible ★ ★ ★ Flame Height Adjustment ★ ★ Standing Pilot* ★ Controller Model Unidirectional LCD Low Battery Indicator Second Burner Thermostat Timer Error Code Notification* ★ Fan Speed Light Dimmer AUX ON/ OFF Fan Delay ON/ OFF Clock Daily Program Thermostat 3 Independent Access Keys *Disabled for Europe 2/3
PAGE 3
TX141—Operating Instructions D03 TURN OFF THE FIRE CHILDPROOF There’s a slide switch can select lock or unlock. Press Lock: The handset is rendered inoperable include the off function. button, NOTE: There is a 3 second delay before the next ignition is possible. MISCELLANEOUS Battery replacement Wiring of valve and receiver must be completed before starting ignition. Failure to do so could damage the electronics. Battery replacement is recommended at the beginning of each heating season.