User's Manual
1 / 15
[GRAND MATE] Version: D05.0 at Dec 19
th
, 2019
GM9K SERIES (INCLUDE GM9K1 / GM9K2 / GM9K3):
GAS FIRED CONTROL SYSTEM
USER MANUAL -FOR OEM USE ONLY
FEATURES
Fire or explosion hazard. Attempted disassembly
or repair of controls can cause property damage,
severe injury or death. Do not disassemble the gas
valve; it contains no serviceable components.
Read these instructions carefully. Failure to follow
them could result in a fire or explosion causing
property damage, personal injury, or loss of life. The
product must be installed and operated according to
all local regulations.
A.
BEFORE OPERATING
verify that no gas is in
the area around the appliance, including near the
floor.
WHAT TO DO
IF
YOU SMELL GAS:
■ Do not light any appliance.
■ Do not touch any electrical switch; do not use
any phone in your building.
■
Immediately call the gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
■ If you cannot reach the gas supplier, call the
fire department.
B.
Use only your hand to push in or turn the gas
control knobs. Never use tools. If a knob will not
push in or turn by hand, don’t try to repair it, call
a qualified service technician. Force or attempted
repair may result in a fire or explosion.
C.
Do not use this control or any gas appliance if any
part has been under water or in contact with water.
Immediately call a qualified service technician to
replace the control system and any gas control
system which has been under water or in contact
with water.
D.
These instructions are to be referenced as a user
guide, and do not supersede appliance manufac-
turer’s lighting instructions.
APPLICATION
GM9K series is an electronic ignition control module
for gas appliances with pilot burners, ODS systems,
remote function, second burner and extra AC/DC
output. Control module is a combination of control
board and power board.
GENERAL NOTES
Multiple Remote Control Solutions:
■ GM9K1 for Unidirectional RF (434 MHz)
■ GM9K2 for Bidirectional RF (434 MHz)
(Support RevoHome SYS.)
■ GM9K3 for Bluetooth
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation. Changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
Primary source(AC):
An AC Main Adapter may be used instead of
batteries. (AC source according to CSA and CE.)
Secondary source(DC):
■ 4 x 1.5V “AA” Batteries.
(quality alkaline recommended)
■ AC to DC 6.5V 1.5A adapter.
NOTE:
■ Power board needed AC power to perform all
functions, while AC power lost, power board
function may lost simultaneously.
■ Electronic ignition control system
■ Ignition by supervised gas-fire pilot burner
■ Support pilot flame sensing:
• Ionization flame detection
• Thermpcouple flame detection
■ Max 9 hours idle auto shutdown
■ Manual control and Remote control
■ Flame height adjustment
■ Flexible combination of AC/DC output to control
FAN, LIGHT, AUX
■ Second burner control
■ Thermostat function
H13