Replacement Parts • Warranty Information (USA) Product Registration (USA) To purchase parts or accessories or for warranty information in the United States, please contact us at the following: To register your Graco product from within the U.S.A. visit us online at www.gracobaby.com/productregistration. We currently do not accept product registrations from those living outside the United States of America. www.gracobaby.
Failure to follow these warnings and the assembly instructions could result in serious injury or death. This device is designed only to monitor the sounds of your child. It will not alert you to your child’s silent activities. When using the monitor, you must still provide the supervision necessary for the continued safety of your child. This product is not designed or intended for use as a medical monitor.
Battery Installation - + - - + Plug in cord + Parent Unit • The battery must be plugged into the Parent Unit before the unit will be ready for use. Remove the battery door cover on the Parent Unit with a key or flat blade screw driver. Remove the battery pack from the packaging and plug into the back of the unit. Place the battery pack into the recess and press the wire into the slot on the side. Replace the battery door.
Low Battery Indication Parent Unit • When the battery is low in the parent unit, the LED bar on the side of the unit will change from green to red and you will hear a series of 3 audible beeps every 5 seconds. If operated too long on a low battery, you may also experience a poor signal and the connection LED on the front of the parent unit may change from green to red and you will begin to hear a continuous audible beep from the Parent Unit.
Operation To Listen To Baby • Turn on Nursery Unit using the ON/OFF switch. • Turn on one or both Parent Units using the ON/OFF switch. • Adjust the volume on the Parent Unit by pressing the Volume Up/Down buttons. Note that the Sound Lights LEDs illuminate as the volume button is pressed up or down to provide a visual feedback for the volume level. The unit will beep louder or softer depending on the volume level.
TroubleShooting DO NOT ATTEMPT to modify the unit. Any modifications to the transmitter and/or receiver can void the operator’s authority to operate the equipment. Most problems have a simple solution. First, check that: Pairing Parent Unit and Child Unit. To ensure privacy, your Parent Unit is paired with your Nursery Unit at the factory. Your Parent Unit will not work with any other Nursery Unit.
Piezas de repuesto • Información sobre la garantía (EE.UU.) Registro del producto (EE.UU.) Para comprar piezas o accesorios o para obtener información sobre la garantía en los Estados Unidos, por favor comuníquese con nosotros en: Para registrar su producto Graco desde dentro de los EE.UU., visítenos en línea en www.gracobaby.com/productregistration. Actualmente no aceptamos registros de los productos de quienes viven fuera de los Estados Unidos de América. www.gracobaby.
No observar estas advertencias y las instrucciones de armado podría resultar en lesiones serias o la muerte. Este dispositivo ha sido diseñado solamente para monitorizar los sonidos de su niño. No le enviará alertas sobre las actividades silenciosas de su niño. Cuando se usa el monitor, debe proporcionar la supervisión necesaria para mantener la continua seguridad de su niño. Este producto no ha sido diseñado ni debe usarse como un monitor médico.
Instalación de las pilas - + - - + Instale la pila + Unidad para padres • La pila debe estar instada en la unidad para padres antes de que la unidad esté lista para su uso. Saque la puerta de las pilas de la unidad para padres con una llave o destornillador plano. Saque el paquete de pilas del empaquetado y enchúfelo a la parte trasera de la unidad. Ponga el paquete de pilas en el compartimiento y oprima el alambre en la ranura del costado. Vuelva a instalar la puerta de las pilas.
Indicador de pilas descargadas Unidad para padres • Cuando la pila está descargada en la Unidad para padres, la barra del diodo electroluminiscente en el costado de la unidad cambiará de verde a rojo y escuchará una serie de 3 sonidos cada 5 segundos.
Prueba del sistema Es MUY IMPORTANTE probar al sistema cuando lo instala por primera vez y periódicamente en adelante. Pruebe las unidades si sospecha que podrían haber resultado dañadas o no han sido usadas durante un tiempo largo. 1. Si hay dos adultos presentes, haga que uno lleve las Unidades para padres a lugares diferentes, probando varios niveles del volumen mientras el otro habla en la Unidad del dormitorio. 2.
SOLUCIÓN DE DESPERFECTOS NO INTENTE MODIFICAR LA UNIDAD. CUALQUIER MODIFICACIÓN AL TRANSMISOR Y/O RECEPTOR PUEDE CANCELAR LA AUTORIDAD DEL OPERADOR PARA USAR EL EQUIPO. La mayoría de los problemas tienen simple solución. Primero, verifique que: Programación de la unidad para padres y la unidad del dormitorio. • La electricidad esté ENCENDIDA en ambas unidades. Para asegurar la privacidad, la unidad para padres se programa con la unidad del dormitorio en la fábrica.