Replacement Parts • Warranty Information (USA) Product Registration (USA) To register your Graco product from within the U.S.A. visit us online at www.gracobaby.com/productregistration. We currently do not accept product registrations from those living outside the United States of America. To purchase parts or accessories or for warranty information in the United States, please contact us at the following: www.gracobaby.
Failure to follow these warnings and the assembly instructions could result in serious injury or death. This device is designed only to monitor the sounds of your child. It will not alert you to your child’s silent activities. This product is not designed or intended for use as a medical monitor. Always be sure that both the transmitter and receiver are working properly and are within range of each other. • STRANGULATION HAZARD. Keep the adapter cords out of the reach of children.
Battery Installation Parent Unit • To replace the batteries, remove the battery door cover on the Parent Unit with a key or flat blade screw driver. • Remove the old batteries from the compartment. • Place 4-AAA (1.5V-LR03) batteries into the battery compartment. Note the proper orientation of the batteries. • Place the battery door back on the unit. • Remove a dead battery promptly. A dead battery left in unit may leak, damaging your unit. • Do not attempt to recharge a non-rechargeable battery.
Selecting Channels • In case you are experiencing some interference, the channel on the Nursery Unit can be changed by switching the channel button on the side of the unit. The Parent Unit and Nursery Unit must both be set to the same channel, either channel “A” or “B” (“X” or “Y”).
Testing the System It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units if you suspect they may have been damaged or have not been used for a long time. 1. If two adults are present, have one take the Parent Unit(s) to different locations, trying various volume settings, while the other speaks into the Nursery Unit. 2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the Nursery Unit to test it. 3.
TroubleShooting DO NOT ATTEMPT to modify the unit. Any modifications to the transmitter and/or receiver can void the operator’s authority to operate the equipment. Most problems have a simple solution. First, check that: • Power is turned ON for both units • Both units are plugged in (or batteries are fresh in Parent Unit) • Electrical outlet works • Volume is turned up on Parent Unit • Parent Unit is in range of the Nursery Unit No Sound • Battery dead or weak — replace or use AC adapter.
Piezas de repuesto • Información sobre la garantía (EE.UU.) Registro del producto (EE.UU.) Para registrar su producto Graco desde dentro de los EE.UU., visítenos en línea en www.gracobebe.com/productregistration. Actualmente no aceptamos registros de los productos de quienes viven fuera de los Estados Unidos de América. Para comprar piezas o accesorios o para obtener información sobre la garantía en los Estados Unidos, por favor comuníquese con nosotros en: www.gracobaby.
No observar estas advertencias y las instrucciones de armado podría resultar en lesiones serias o la muerte. Este dispositivo ha sido diseñado solamente para monitorizar los sonidos de su niño. No le enviará alertas sobre las actividades silenciosas de su niño. Este producto no ha sido diseñado ni debe usarse como un monitor médico. Tenga siempre la seguridad de que el transmisor y el receptor funcionan correctamente y se encuentran a la distancia requerida. • PELIGRO DE ESTRANGULACIÓN.
Instalación de las pilas Unidad para padres • Para cambiar las pilas, saque la puerta de las pilas de la Unidad para padres con una llave o destornillador plano. • Saque las pilas gastadas del compartimiento. • Ponga 4 pilas tamaño AAA (1,5V-LR03) en el compartimiento de las pilas. Note la orientación correcta de las pilas. • Ponga la puerta de las pilas de nuevo en la unidad. • Saque la pila descargada inmediatamente. Una pila descargada en la unidad podría perder y dañar a la unidad.
Selección de canales • En caso de experimentar alguna interferencia, el canal de la Unidad del dormitorio puede cambiarse oprimiendo el botón del canal en el costado de la unidad. La Unidad para padres y la Unidad del dormitorio deben usar el mismo canal, el canal “A” o “B” (“X” o “Y”).
Prueba del sistema Es MUY IMPORTANTE probar al sistema cuando lo instala por primera vez y periódicamente en adelante. Pruebe las unidades si sospecha que podrían haber resultado dañadas o no han sido usadas durante un tiempo largo. 1. Si hay dos adultos presentes, haga que uno lleve las Unidades para padres a lugares diferentes, probando varios niveles del volumen mientras el otro habla en la Unidad del dormitorio. 2.
Solución de desperfectos NO INTENTE modificar la unidad. Cualquier modificación al transmisor y/o receptor puede cancelar la autoridad del operador para usar el equipo. La mayoría de los problemas tienen simple solución.