Sol Jam Models: GDI-EXSJ400 / 401 User Guide
Quick Start 1 2 3 4 5 Open Cap on the back of your Sol Jam Turn on the Main Power Switch Press the Standby Button to power on your Sol Jam Search your Bluetooth Connection on your Smart Device Pair & Play LED Status Indicators Power, Battery, Bluetooth Control Buttons
LIMITED MANUFACTURER’S WARRANTY: The Sol Jam is covered by a 3 year limited warranty that covers defects in workmanship and / or materials for a period of 3 years from original purchase date. This warranty does not apply to any products which have been abused, neglected, modified, or used for a purpose other than the one for which they were manufactured. Please refer to the above care and maintenance instructions for suggested care details.
Your Sol Jam will beep to indicate when maximum volume setting is reached. Track Selection Press button once to select Previous Song track & Next Song track . Play/Pause/Answer Press button once to pause & play song tracks and to answer mobile calls (MUST be paired with Bluetooth). Battery Level Press the button to check the battery level. There are five LED battery level indicators located on the top of the unit. Each LED represents 20% of a charge. Five full LEDs indicate a full charge.
You should never 1) Never charge your ECOXGEAR if you suspect water has entered the device. Charging a device with water inside could be potentially hazardous and cause fire or a spark. 2) Never use your ECOXGEAR if you have dropped it or thrown it against a hard surface which may have destroyed the integrity of the speakers, housings, or gaskets. In the event of a severe impact to your unit please return the unit to Grace Digital to review for potential damage.
charging Sol Jam, the blue LEDs will sequentially flash – 1 flashing LED is low sun charging, and 5 sequentially flashing LEDs is optimal charging. The efficiency of the solar charging varies based on a variety of factors: angle of the sun, global location, time of day, time of year, and cloud cover. Battery Level Check the charge of the battery by pressing the Battery Level Button on the Sol Jam unit: 1 solid LED indicates 20% charged, 5 solid LEDs indicate fully charged.
WARNING: This product may contain chemicals listed in Proposition 65 (www.oehha.ca. gov/prop65/prop65_list/Newlist.html) WARNING: Sol Jam has a built-in Lithium battery. The battery must NOT be used in or near an open heat source or excessive heat. WARNING: Danger of explosion if battery is incorrectly replaced. ATTENTION: Do NOT dispose of in a landfill. Contact Grace Digital at www.gracesupport.com or a certified recycling agent to dispose of the unit.
2 Power ON, Battery, & LED Status Indicators Once fully charged, press the Standby Power Button on your Sol Jam. You will see the green LED light & you will hear an ascending bell tone. IMPORTANT: Ensure the Main Power Switch, located in the back compartment under the cap, is set in the Upper ON position. If the switch is in the Lower OFF position, your Sol Jam will not be able to turn on using the Standby Button. NOTE: The LED battery level indicators are located on the top of the unit.
FCC COMPLIANCE STATEMENT & WARNING: This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio frequency energy & if not installed & used in accordance with instructions may cause harmful interference to radio communications.
Once connected, select and play your desired audio. Pairing Mode: If the LED is not flashing or if you wish to place your Sol Jam in pairing mode, press and release the Bluetooth Button . Your Sol Jam shall announce “pairing ready” when ready to pair to a new device. NOTE: Your Sol Jam shall sync & wirelessly pair with most Bluetooth enabled devices.
Solar Panel Photovoltaic (PV) Solar Charge Charging Options Solar, USB to AC adapter, USB to computer Charging Time Approx. 3 hrs (AC adapter) Solar charge rate varies with environmental conditions Play Time 12+ hours from full charge at 75% volume level USB Input / Output 5V, 1A Waterproof / Dust Rating IP67 to learn how to add and pair a new device (Sol Jam for instance) to your Smartphone using Bluetooth.
Master Power Switch & Connections To access the connections, turn the cap to the LEFT so the cap’s arrow point lines up with the unlocked symbol along the back edge of the unit. 1 2 3 Specifications Unit Dimensions 3.1” 5.0” Select Unlocked OFF ON OFF AUDIO AUX-IN INPUT AUDIO AUX-IN INPUT Open Cap OUTPUT OUTPUT ON Mount Attachment Point Access Connections Unit Weight 25.1 ounces Output Power RMS 20W (10 Watt x2 speakers/ 4 ohms) S/N Ratio 88dB +/- 3dB Power Source 3.
Output Connect to the USB Output (5V, 1A) port to charge your personal device. Use the USB cable included with your personal device. NOTE: Charging rates are similar to the charging rate when connected to the USB of a desktop PC. Charge time is approximately 3 hours from low to full for most Smartphones; however, charge times will vary depending on the device being charged, the device’s battery specifications, and the device features.
Back Panel: Functions OUTPUT ON OFF Audio AUX-IN AUDIO AUX-IN INPUT Connect an audio device using the 3.5mm cable connection as an alternative to a Bluetooth connection to your Sol Jam. NOTE: Volume level must be controlled from the audio device when connected to the AUX-IN connection. Input Master Power Switch Sol Jam has a separate Master Power Switch and a Standby Button. The switch MUST be set to the ON position to power your Sol Jam.