Installation Instructions

Add Device
Add Device
Ap Mode
Cancel
Add Device
Add Manually Search Device
Elec tri cal
Smar t
Ligh ting
Home
Appl iance.. .
Home
Appl iance.. .
Wal l
Switch
Wal l
Switch
(bluetooth)
Wal l
Switch
(ZigBee)
Electr ic al
Outlet
Electr ic al
Outlet
(bluetooth)
Electr ic al
Outlet
(ZigBee)
Add Device
TuyaSmart
Smart Life
GO SMART
Done aleax.gosund.com
Link Account
The following Apps al l support skill.Please
select an App an App to log in
Light
Time
Countdown
Outdoor Switch
Long press to edit switch name
Any problems please follow Gosund
on and consult the service staff
402-000-0264
Smart Wi-Fi Light Switch, 3-way Kit
Intelligent switch
SW2
Input: 100-240V~,50/60Hz
Max output: 150W LED/CFL, 250W INC/HAL,
1.5A ceiling fan
Wi-Fi: 802.11 b/g/n, 2.4GHz(only)
Make sure your wiring is compatible. The Gosund
fan control & Light dimmer replaces single pole
switches only. If your light can be turned on from
two different wall switches, that’s a 3-way switch
and Gosund fan control & Light dimmer is not
compatible.
FCC:
This device complies with part 15 of the FCC Rules. Operation is
subject to the condition that this device does not cause harmful
interference (1) this device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
To maintain compliance with FCC’s RF Exposure guidelines, This
equipment should be installed and operated with minimum
distance between 20cm the radiator your body: Use only the
supplied antenna.
FCC ID: 2APUZ-SW2