GOSAFE SYSTEMS 777 Tracking Unit End User Manual - Distributor Document Title: 777 Tracking Unit End User Manual -Distributor Version number: V2.02 Prepared by: Mr. Chen Approved by: Mr.
Copyright © 2012 All Rights Reserved Gosafe Company Limited Revision Sheet Rev No. Change Summary Date 1.0 First Document 2011.04.27 2.0 1． Upload mode add to ”S” mode （UUM/SSM/TPM/UPM command） 2． Server port default：3032 （SIP command） 3． Server address domain default: empty (SDM command) 2011.05.16 3 1. 2. 2012.07.31 Modified Chapter4.2 Insert SIM card Updated device appearance photos Note: A full description of future changes will be found in the GoSafe Company Change Notes.
Copyright © 2012 All Rights Reserved Gosafe Company Limited Abbreviations Abbreviation °C µA APN g G GHz GPRS GPS GSM KB Km/h LBS mA mAH MCU MHz mm MOT OBD II OEM PIN PQR RAM RFID S SMS SOP SPD UAC UNO UPW UTC V0.12 VOM Doc. No: 777 -DST Rev. No: 1.
Gosafe Company Limited Copyright © 2012 All Rights Reserved Terms and Definitions Geo-fence A geo-fence is a virtual boundary around a physical geographical space. A geo-fence consists of a set of coordinates that define an area.
Gosafe Company Limited Copyright © 2012 All Rights Reserved Table of Contents 1.0 INTRODUCTION ......................................................................................................................................... 8 1.1 Purpose .............................................................................................................................................. 9 1.2 Scope ............................................................................................................
Gosafe Company Limited Copyright © 2012 All Rights Reserved 8.1 LED Flashes & Relevant Device Status ............................................................................................. 28 9.0 CONTACT DETAILS ................................................................................................................................... 29 Doc. No: 777 -DST Rev. No: 1.
Gosafe Company Limited Copyright © 2012 All Rights Reserved List of Figures Figure 1: - Communication lines between the various products and 777 ........................................................ 8 Figure 2 – 777 Component Illustration ............................................................................................................ 10 List of Tables Table 1 – 777 Unit Specification ...........................................................................................................
Gosafe Company Limited Copyright © 2012 All Rights Reserved 1.0 INTRODUCTION This new tracking unit is designed by the Gosafe Company Limited and the “Connect & Go” concept of the 777 enables the unit to interface with an OBDII diagnostic port of the vehicle which provides real time performance parameters on the engine as well as driver behaviour. While the 777 is plugged into the ODBII port, power to the tracking unit is received from the vehicle electrical system.
Gosafe Company Limited 1.1 Copyright © 2012 All Rights Reserved Purpose The purpose of this document is to provide guidance to the user during the installation and set-up of a newly procured 777 tracking unit. 1.2 Scope The document covers the following aspects: Section 2 - Key Features: A short summary of the key features of the 777 product is provided. Section 3 - Unit Specification: The 777 physical, electrical and environmental performance specifications are provided.
Copyright © 2012 All Rights Reserved Gosafe Company Limited Figure 2 illustrates the complete 777 tracking unit which is installed into your asset. Figure 2 – 777 Component Illustration Description Unit Illustration OBDII plug to connect with vehicle port Rear View with USB port and microphone Complete Set with USB Cable Doc. No: 777 -DST Rev. No: 1.
Gosafe Company Limited Copyright © 2012 All Rights Reserved 2.0 KEY FEATURES The main features of the 777 are: Real Time Location Mobile Map Location Latitude and Longitude Location GSM Base Station Location（LBS Technology） Convenient GSM Mobile Control Easy-to-use SMS Communication Mode Internal Movement Sensor for better power management Internal backup battery for Device disconnection notification Internal memory for the data buffer Doc. No: 777 -DST Rev. No: 1.
Gosafe Company Limited Copyright © 2012 All Rights Reserved 3.0 UNIT SPECIFICATIONS Table 1 – 777 Unit Specification Physical Specification Power MCU Size Weight IP Rating Rechargeable Battery Power Consumption MCU Antenna Modem Frequency GPRS GSM Approvals SIM card LBS Location Accuracy GPS Antenna Receiver Channels Sensitivity Navigation update Acquisition Location Accuracy Sensor Memory Environmental Conditions Doc. No: 777 -DST Rev. No: 1.
Copyright © 2012 All Rights Reserved Gosafe Company Limited 4.0 INSTALLATION PROCEDURE 4.1 Sequence The recommended sequence for the installing the 777 unit is: Installing the SIM Card into the Unit Configuring the 777 Unit 4.2 SIM Card Installation Before commencing with the 777 installation, insert a SIM card which operates on your local GSM network which has a General Packet Radio Service (GPRS) facility.
Gosafe Company Limited Copyright © 2012 All Rights Reserved Step 4: Push the circuit board slowly into the casing until flush with the front. Attach the front cover and tighten the screws. 4.3 Locating OBDII Port ODBII ports are available since 1996 but most vehicles manufacturers had it as a standard feature since 2000. Contact your vehicle dealership to establish exactly where the port has been installed inside the vehicle cabin. Some ports are located under the dash whilst others between the seats.
Gosafe Company Limited 4.5 Copyright © 2012 All Rights Reserved Configuration Set-Up Note: To configure the 777 tracking unit the USB drivers needs to be downloaded from the following website: http://www.gosafesystem.com/downloads.asp Click on the 777 USB driver to initiate the download. After downloading the USB drivers, the connections between the 777 unit, your computer and ODBII port needs to be established by: The 777 is supplied with a USB cable.
Gosafe Company Limited Copyright © 2012 All Rights Reserved 5.0 UNIT SET-UP PROCEDURE The end user of the 777 will now be guided to set-up and personalised the settings on a newly fitted tracking unit into a vehicle also called the asset. This ensures safe communication between the end user and the unit and protects valuable data against misuse by dubious people. Notes: 1. A mobile phone is required to perform the personalised set-up.
Gosafe Company Limited Copyright © 2012 All Rights Reserved Notes: 1. Please memorize your New Password and wait for the confirmation by SMS that your password modification was successful. 2. The system can only process the command if there is a UNO registered by the Fleet Manager. 5.3.
Gosafe Company Limited Copyright © 2012 All Rights Reserved settings need to be submitted before the unit will respond accordingly. Operating Cycle: xxxS: Seconds upload range (30 ~ 900 seconds) xxxM: Minute upload range (15 ~ 59 minutes) xxxH: Hour upload range (1 ~ 240 hours) Work Modes: O: --Cancel Upload G: --If there is GPS data, send GPS based location. If not, send GSM base station (LBS) data.
Gosafe Company Limited Copyright © 2012 All Rights Reserved “alert speed” threshold must be smaller than the “over speed alarm” threshold. Command format: **** , SOP ; Alert Speed ; Alarm Speed Explanation: **** , User password (4-digit) Command delimiter Command Control Word Command delimiter Set the speed in KM/H (Default setting 80 km/h) Command delimiter Set the speed in KM/H (Default setting 100 km/h) SOP ; Alert Speed ; Alarm Speed SMS this command setting to the Message Centre.
Gosafe Company Limited Copyright © 2012 All Rights Reserved uninterrupted stationery period, will the unit responds to a movement. The expected reply： Enable SMS upload when movement trigger, command is: 1234,MOT;1 Disable SMS upload when movement trigger, command is: 1234,MOT;0 5.3.6 Set Voice Monitoring Number (VOM) This is to activate or de activate the voice monitoring feature on the tracking unit.
Gosafe Company Limited Copyright © 2012 All Rights Reserved 777 V0.17 GPS 5/67 UTC 11-05-11 06:47 N23.164367 E113.428548 SPD:0km/h TMP:37.8C PWR:10.5V Notes: 1. N = North, E = East, W = West and S = South 2. A negative represent Western Time zone, a positive represent Eastern Time zone. 2. By calling the Unit Number and hang up after the first ring, the device will send back the GPS location to the user mobile phone.
Gosafe Company Limited Copyright © 2012 All Rights Reserved the unit will receive and process the commands in real-time and reply accordingly. 5.5 Alarms The unit transpond alarms when certain conditions or parameters are triggered. The expected messages to receive when the unit is in the alarm state are listed in table 2: Table 2 - List of Alarms SMS Received 777 V0.12 GPS 6/77 UTC 11-05-14 05:33:47 N23.164479 E113.428606 SPD:0km/h 0 Alarm: Power Off 777 V0.12 GPS 6/77 UTC 11-05-14 05:33:47 N23.
Gosafe Company Limited Copyright © 2012 All Rights Reserved Table 3 – Default Parameters Description User number SMS center number PIN code of SIM APN list User password User upload mode Manager phone number Manager upload mode Server IP or domain name TCP port UDP port TCP channel upload mode (mode 0) UDP channel upload mode (mode 0) Package number per TCP upload Package number per UDP upload Percentage of data buffer per TPC upload Percentage of data buffer per UDP upload Over speed Enable/ disable over
Copyright © 2012 All Rights Reserved Gosafe Company Limited 2. The “combine command” function is only available to the mobile phone number of the registered user.
Gosafe Company Limited 6.0 Copyright © 2012 All Rights Reserved OPERATIONAL TESTS A few simple tests by the user can be conducted after the set-up is completed to establish whether the unit is functioning correctly in the vehicle. This is done by running a set of checks on set parameters to verify “a day in the life” of the 777 tracking unit. Two sets of checks are done: 6.1 Alarm Checks With this check the user verifies whether alarm reports are send when pre-set threshold values are exceeded.
Copyright © 2012 All Rights Reserved Gosafe Company Limited 7.0 UNIT SMS STRUCTURES The SMS and hyperlink formats for every Fleet Management Platform is unique and should be obtained from the specific fleet manager. Below the GoSafe fleet management platform format details. 7.1 Normal Location (G Mode) SMS Format (T Mode) (Successfully Located) Gosafe 777 V0.10 GPS 3/56 LTM08:00 11-24-10 02:54 N23 9.8329 E113 25.7149 Speed: 1km/h 39 TMP=25.6C PWR=12.
Gosafe Company Limited 7.4 Copyright © 2012 All Rights Reserved Password Modification Successful Confirmation Gosafe 777 V0.10 UPW:5678 7.5 User No Setting Successful Confirmation Gosafe 777 V0.10 UNO:+8613912345678 Doc. No: 777 -DST Rev. No: 1.
Gosafe Company Limited Copyright © 2012 All Rights Reserved 8.0 TROUBLE SHOOTING 8.1 LED Flashes & Relevant Device Status An external flashing LED light, next to the USB port, reflects the operational status of the unit. The LED will flash at 8-sec intervals to indicate the GSM and GPS operational status. There is a short interval between each flashing cycle, first the GSM then followed by the GPS status.
Gosafe Company Limited 9.0 Copyright © 2012 All Rights Reserved CONTACT DETAILS Gosafe Company, Ltd in China: Tel: +86 (20) 6667 9696 Fax: +86 (20) 6667 5900 Enquiry: info@gosafesystem.com Support: support@gosafesystem.com Online Support: gosafe.support (skype) Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
