Installation Instructions

Get started in three simple steps:
1. Plug the power cable into the device.
2. Plug the power adapter into a wall outlet.
3. Please download and run the APP on a phone or tablet.
4. Finish setting up the device through the APP.
Regulatory Information: United States
FCC Regulatory Compliance
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the manufacture could void your authority
to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2
conditions:
1. These devices may not cause harmful interference.
2. These devices must accept any interference received, including interference that may cause
undesired operation.
Responsible party – U.S. contact information
Google LLC, 1600 Amphitheatre Parkway, Mountain View, CA 94043.
Contact : https://g.co/nest/contact
Radio Frequency Exposure
This device meets the U.S. Federal Communications Commission's (FCC) requirements for exposure
to radio waves and is designed and manufactured not to exceed the FCC's emission limits for
exposure to radio frequency (RF) energy. To comply with FCC RF exposure compliance
requirements, a distance of at least 20 cm should be maintained between the antenna of this device
and persons during device operation. This device must not be co-located or operating in conjunction
with any other antenna or transmitter.