Walgreens Installation Guide G-1-2002-2B 5/27/2008
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Table of Contents CHAPTER 1 - INTRODUCTION:.............................................................................. 1-1 Reminder:......................................................................................................................... 1-1 Prior to Installation:........................................................................................................... 1-1 Ceiling Tiles:.........................
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Suspended Mount Procedures: ............................................................................................... 2-62 Wall Mounted Procedures: ......................................................................................................2-64 Exception Stores: ......................................................................................................................... 2-67 Sheet Rock or Wood Ceilings.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Store Data Form:............................................................................................................B-13 Installation Exception Form:.........................................................................................................B-14 Store Cable Length Form:............................................................................................................
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Document Title: Walgreens Installation Guide Revision Page(s) Number 2B - 5/27/2008 2-1 Update Help Desk phone number to 207-591-1583 1-3 Add contact Help desk immediately if an accident occurs during the store installation. 1-3, 2-2, 2-14, 2-16, B-16 Update access to Pharmacy Policy. 2-3 Wood and sheet rock Ceiling added to issues.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Chapter 1 - INTRODUCTION: The Walgreens Installation Guide (G-1-2002) defines the standard installation processes and requirements for the installation of the Goliath Solutions System in the Walgreens environment. Walgreens stores will be installed by a contracted Cable Installation Team (CIT). The target audience for this manual is the CIT and the Goliath Solutions Help Desk (Help Desk).
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Ceiling Tiles: During the survey and installation you will be handling ceiling tiles in your work area. Be careful when removing and replacing the ceiling tiles so you do not damage or mark the ceiling tiles. Make sure your hands are clean and free of debris when handling ceiling tiles. Always remove the ceiling tile when you are standing on a ladder, never use a pole to remove a ceiling tile.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Walgreens Environment: The installation is taking place in a live store environment with employees and customers. The CIT must at all times be aware of this environment. Goliath Solutions and the CIT are guests of Walgreens and must follow Walgreens vendor policies. The following items are a summary of those policies. Always be polite to store employees and customers. Follow store safety procedures.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Chapter 2 - STORE INSTALLATION PROCEDURES: Check-In: Morning installations start at 8 AM local time. Upon arrival, the following tasks must be completed: 1) Locate the highest available level of Store Management (the Store Manager’s name is posted near the front door). The Lead Tech must introduce himself and the crew.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Pre-Installation Store Survey: Introduction: Using the provided store floor plan and the Pre-installation Survey Checklist (located In Appendix B – Support Documents) perform the Pre-installation Store Survey. The survey will determine the actual location of the Goliath equipment, any exception issues with the installation and the path of the cable pulls.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc During the Pre-Installation Survey the following information will be determined: 1) Validate that the provided store floor plan is correct. 2) Validate if power is available by the front security screen for the MEU. 3) Location and power source for the CMU. 4) Location, power source and the mounting method for the MEU. 5) Access point into the stock room for cables. 6) If a second MEU will be required.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Estimating Cable Lengths: During the survey you will be estimating the distances between the GOLIATH antennas (TX/ATA and Rx/ARA) and the MEU to determine what length of cables to use for each antenna. You must also verify that distance does not exceed the maximum supported cable lengths listed below.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Validate the Store Floor Plan: The first step in the pre-installation store survey is to validate that the provided store floor plan is correct and matches the actual store floor plan. If the store floor plan is not correct; go to the Floor Plan Questions section found in the “Walgreens Store Floor Plan Reference Guide”. Gather the information asked in these questions and then contact the Help Desk.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Catalina Cabinet behind the photo machine Network cables run through the wall into the back of the Catalina cabinet. Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions, LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc 2) If the store has a Catalina Cabinet then go to step 3, otherwise the CMU will be located by the Communications Cabinet in the Pharmacy. Only enter the Pharmacy if there is no Catalina Cabinet in the store. Notify the highest available level of Store Management that you will need access to the Pharmacy. When in the pharmacy the CIT must be accompanied by a Pharmacist that is on duty at all times.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc d) Validate that the port designated for Goliath is available on the switch. Port 46 on the 48 Port Switch Ports only used to connect switches together or to the patch panel. Patch cable with orange cap runs to the patch panel.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc f) If the above conditions are present, then determine a location on the wall either inside of the cabinet on the back wall or on the wall next to the cabinet to mount the CMU. Next to the cabinet is the preferred location. The CMU should be at eye level or above. If power or a designated port on the patch panel is not available then contact the Help Desk at the completion of the Pre-installation survey.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc 3) Open the Catalina cabinet and validate the following information: Determine if the cabinet has either a 48 port switch or two 24 port switches. o If the switch is a 48 port, then validate that port 46 is open for Goliath. o If there are two 24 port switches, then validate that port 22 on switch 2 is open for Goliath.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Ports only used to connect switches together or to the patch panel. Port 46 on the 48 Port Switch Port 46 Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions, LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc b) The following pictures show examples of two 24 port switches in a Catalina Cabinet. The CMU patch cable will always plug into port 22 on switch 2. o To determine switch 2, look for the orange patch cable running from the patch panel to one of the switches. Sometimes the cable can be a different color. Only one orange patch cable should be used. The switch that the orange patch cable is plugged into is switch 1.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Ports 1-8 Ports 9-16 Port 22 Ports only used to connect switches together or to the patch panel. Orange Patch Cable connected to Switch 1 Port 22 on Switch 2 Patch cable connecting Switch 1 and Switch 2 Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions, LLC.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc 4) Determine the location to mount the CMU on the wall. The CMU will normally be mounted near the INDYME device. Review the following criteria to determine the location. INDYME Device CMU The CMU should be mounted about eye level or above the cabinet. The CMU should not be mounted over 1 foot higher than the top of the cabinet. The CMU/MEU power supply brick must be inside the Catalina cabinet.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Knock Out hole CMU/MEU low voltage cable and power supply (Power Brick) 6 foot power cable for power supply REMEMBER: BOTH A DEDICATED UNINTERRUPTED POWER OUTLET AND A NETWORK CONNECTION MUST BE PRESENT AT THE CMU LOCATION! Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions, LLC.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Determine the Primary MEU Installation Location: The MEU location marked on the store floor plan is only a suggested location. The actual location is determined during the Pre-installation Store Survey by reviewing the following criteria: 1) The MEU power source. The power source for the MEU must be an open uninterrupted 24-hour power source.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc 3) Use the following criteria to determine the MEU location and mounting method. The location and distance from the MEU to its power source. The distance from the MEU to all of the Tx/ATA and Rx/ARA antennas. o Cable length limitations are: 110 foot for the power cable 110 foot for the Tx/ATA 135 foot for the Rx/ARA Minimal service loops must be at the MEU and antenna locations.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Please refer to the following table for suggested locations for the MEU. The primary MEU must always be mounted or suspended in the ceiling near the center of the sales floor, but never directly over the middle aisle.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Determine if a Second MEU is required: Most stores will require only one MEU. But some exception stores will require a second MEU. If a second MEU is required it will normally be located in the stock room. Stores with a basement or second floor stock room will frequently require a second MEU.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc Determine the Tx/ATA and Rx/ARA Antennae Placement: 1) Using the “Pre-installation Survey Check-list” and the store floor plan, walk the store and determine the location for the placement of the Tx/ATA and Rx/ARA antennae for both the sales floor and the stock room. Refer to “Appendix A - Antenna Placement” of this guide for more detailed information on the placement of each antennae.
Walgreens Installation Guide G-1-2002-2B Walgreens Installation Guide 2B.doc 4) Mark the location of the Tx/ATA or Rx/ARA antennae on the floor directly below the selected ceiling tile location or the roof iron. Use the assigned antenna number found on the store floor plan for that location when marking the floor. When marking the location on the floor, you must use painters tape. Write the antenna’s number on the painters tape prior to placing on the floor.